Last Activity:05-25-2009 6:45 PM
Posted in thread: Volume in a package in insulation? on 06-26-2009 at 08:06 PM
I am talking about the pink fiberglass insulation. My crawlspace has a concrete wall, and on
top of that is the framing of the house. This framing is about 12 inches high till I get to the
Posted in thread: Kinda bummed out-cannot get a Heat Pump on 05-25-2009 at 05:45 PM
Thanks for the replies, but I am starting to lean towards just getting a gas furnace installed.
For those with a gas furnace installed, what size breaker are they linked to?Thanks again for
the all re...
Posted in thread: Kinda bummed out-cannot get a Heat Pump on 05-22-2009 at 07:05 PM
I had someday planned on getting a heat pump installed in my house to both heating the AC. I
currently have 2 gas fireplaces at each end of the house, and that is fine except the center of
the house (...
Posted in thread: Dryer extension cord on 04-19-2009 at 08:44 PM
My mistake. Yes it is a washer, not the dryer that I am asking about. Thanks for the excellent
Posted in thread: Dryer extension cord on 04-19-2009 at 02:50 PM
I bought a new clothes washer, and the plug in is 8 inches short the receptacle, so I found a
short extension cord that is 3 prong, and the same gauge as the cord for the washer, and it
works fine. Th...
Posted in thread: Tips for cutting through stucco on 04-04-2009 at 12:24 PM
Thanks. I am looking at drilling up to 1 1/4 inch hole, and my next question is what type of
drill bit would work for this job? Reason for so big a hole is so I can slide a PC tube through
to run the ...
Posted in thread: Tips for cutting through stucco on 03-25-2009 at 01:09 PM
I have a crawlspace with concrete foundation, and from there is the wood foundation. On the
exterior of the house is the foundation, and above that is stucco. I need to run some wire from
the crawl sp...
Posted in thread: Precautions when cutting concrete on 03-25-2009 at 01:06 PM
In your case, I would rent the gas powered concrete cutter, and ask the rental guy about the
possibility of rebar. I am cutting a small square, and I doubt there is any rebar in there as
it is only a ...
Posted in thread: Precautions when cutting concrete on 03-24-2009 at 06:01 PM
Thanks for the replies and precautions. I was looking at the diamond wheel blades, and the ones
I was looking at can be cut dry. I will do that and take shallow cuts till I get a good groove
in the co...
Posted in thread: Precautions when cutting concrete on 03-07-2009 at 11:14 AM
I am going to be cutting a 12X12 inch square hole in a concrete slab to accommodate a drain
box, and was hoping to get some cutting tips from you who have done this before. I am going to
get a diamond...
- Your house is how old?
- Paint Chiping in Bathtub
- Driveway Sealer
- drylocking basement and removing mold on concrete
- Bathroom tiling
- Flooding Driveway
- One Word Game
- Completed Sanding, two questions before applying urethane finish.
- Install Quarter Round when there is large gap underneath the baseboard?
- Sistering floor joists in my hunting cabin to stop floor movement
- Shower pan
- Need opinions on what to do here... (Pics Included)
- Possible mold problems??
- Need some help
- Looking for new HVAC and move furnace?
- Exhaust Fan In Bathroom