VIEW MY

ozone

Gift Premium Subscription To ozone

Join Date:

11-20-2010

Last Activity:

04-22-2014 9:21 AM

1 Likes on 1 Posts 

  • Shelby Twp.
  • Michigan

LATEST ACTIVITY

  • Posted in thread: Furnace Noise during startup on 11-06-2013 at 09:59 AM
    Many HVAC parts are available from Amazon. I know they sell FASCO inducers as well as showing
    cross-references for proper application. Reading the customer reviews might also give the OP a
    better idea...

  • Posted in thread: Air Conditioner, Cover or Not? on 02-26-2013 at 06:35 AM
    Good replies that I would totally agree with, especially the damage that can be done from
    icicles and ice slides off the roof. One issue not mentioned is that when a full cover is used
    it not only hol...

  • Posted in thread: York stellar furnace acting up on 01-04-2013 at 06:26 AM
    Yes, that is the collector box. When you install the new one you should be using high
    temperature red silicone caulk to get a moisture/pressure seal. If you damaged your inducer
    gasket when you took i...

  • Posted in thread: York stellar furnace acting up on 01-03-2013 at 09:32 AM
    Regarding your question in post #8.If your refering to the plastic cover between the lower area
    of the heat exchanger and the inducer, (combustion fan). Then you are refering to the
    "collector box".

  • Posted in thread: Rusting Cast Iron Stack on 12-19-2012 at 09:19 AM
    As mentioned above, rust is a natural occurance for cast iron that is not a problem. If your
    issue with it is appearance then you could try a product/chemical called "ospho". I have used
    it many times...

  • Posted in thread: Locking tabs on 12-07-2012 at 06:48 PM
    I know that zip screwing it in will work fine, but if clips are what you want you may find the
    correct interchangable ones at this, or another such link: Luck

  • Posted in thread: Locking tabs on 12-07-2012 at 08:46 AM
    I think in time all those plastic door clips become brittle and easily break. Occasionally you
    luck out and the door has four clips and only the top two are used/needed as the bottom is held
    in place ...

  • Posted in thread: A/C placement on 04-21-2012 at 10:18 AM
    I must admit having only experience in the installation of split, mini-split, and the normally
    placed window AC system. With that in mind I can't speak with familiarity to all the issues
    that a projec...

  • Posted in thread: Mysterious Leak on 04-04-2012 at 03:36 PM
    You state the majority of the home is serviced by a hot water system. By chance do you have a
    secondary forced-air system with a humidifier? If so they are usually plumbed to the hot water
    supply side...

  • Posted in thread: capacitor on 09-10-2011 at 07:39 AM
    6% is the same as .06, so 7.5 X .06 = .45. Your -/+ tolerance would be 7.05 to 7.95. If you
    carry a cell phone you can use the "Tip Calculator" tool. $7.50 meal, 6% tip = $.45.

0 COMMENTS
POST A COMMENT