pbv

LATEST ACTIVITY

• Posted in thread: Door project on 12-07-2012 at 07:16 PM
  OK,Here goes:I have edited the original CAD to include the "dressing up on the outside as well
  as the 3/4 inch hinge jamb and sandwiched the 2x4 box frame between the plywood layers.Please
  look it ove...

• Posted in thread: Door project on 12-07-2012 at 06:04 PM
  So it would be better then, to use a wood plank. 4.5 inches wide x 3/4 inches thick to act as
  the jamb. I would flush mount this to the exterior wall and then shim it plumb vertically to
  ensure the do...

• Posted in thread: Door project on 12-06-2012 at 09:04 PM
  Sorry for the delay, work has been busy. I have not built the door in any way yet. Only the
  rough opening for the door is there. It only exists as a CAD drawing.You think it would be
  better to place a...

• Posted in thread: Door project on 12-03-2012 at 09:11 PM
  The door in my cad is 4.5 inches thick. I was going to use 4 inch wide wood panels over the
  face to cover the gap on the left (non-hinge) side.I expect the door to weigh approx 200-250lbs
  when complet...

• Posted in thread: Door project on 12-02-2012 at 08:29 PM
  Hello,This is my first post so I am sorry if anything comes across as confusing. I am planning
  on replacing the door a utility room in my house. Currently we use it to store bedding,
  cleaning supplies...