prh44

LATEST ACTIVITY

• Posted in thread: Favorite Childhood Toy on 04-07-2012 at 09:17 PM
  Remember the SSP racers

• Posted in thread: Is there a difference on 02-15-2012 at 07:23 PM
  If you look at an incandescent lamp you will see the voltage marked on the top of the lamp.
  They will normally be rated 120 volt. If you look around you will find some that rated at 130
  volt. This lam...

• Posted in thread: Favorite Childhood Toy on 02-15-2012 at 05:44 PM
  YARD DARTS!!.. Cant get them new anymore

• Posted in thread: Adding new receptacle and switch on 02-14-2012 at 08:07 PM
  One wire per terminal is required on most devices

• Posted in thread: Adding new receptacle and switch on 02-14-2012 at 08:05 PM
  In this case you are fine with out pigtails. The install meets NEC requirements. Pigtails are
  better when wiring multiply devices. This keeps down strean current flow from going through the
  upstream d...

• Posted in thread: I want to add switches to three outlets that are tied together on 02-14-2012 at 07:49 PM
  That will work fine

• Posted in thread: Washer Drain Question? on 01-22-2012 at 05:41 PM
  I can place the drain up to 8' above the base according to the specifications of the washer. I
  can install a vent up to the attic and tie into the main vent very easily.

• Posted in thread: Washer Drain Question? on 01-22-2012 at 01:46 PM
  You will probably have water shoot out from the standpipe when a toilet is flushed on the
  floor above using that low heel inlet 90 elbow. I was concerned about that. What if I place a
  tap in the mani...

• Posted in thread: Washer Drain Question? on 01-22-2012 at 09:46 AM
  I am installing a washer in my basement. My invert on the main sanatary is 3'-7-7/8". I have
  attached a drawing of the capped line I would like to use. It is 1.5" PVC. drain. 1. Can a
  washer pump this...