Last Activity:11-24-2006 6:07 PM
Posted in thread: Sensor Switch on 11-24-2006 at 08:26 PM
That makes a HUGE difference. You have a switch loop. You CANNOT make this work from this box.
You'll need to find another source for your feed.Thanks petey_racerI figured that I would have
to find an...
Posted in thread: Sensor Switch on 11-24-2006 at 05:07 PM
Yes I was there yesterday and I only have two sets of wires. The one new receptacle wires and
the other set comes in live to the switch. So any suggestions how to make it work.Thanks
Posted in thread: Sensor Switch on 11-20-2006 at 06:05 PM
Your switch box should have three cables coming it. If it doesn't your can't do it.Connect all
three whites together.Connect the power in black to your new cable black nd the sensor
Posted in thread: Sensor Switch on 11-20-2006 at 03:38 PM
You got the 14/2 wire coming from breaker and 14/2 from the light. Everything meets in the box
where the switch is .Thanks Radioman
Posted in thread: Sensor Switch on 11-20-2006 at 07:54 AM
Hello The sensor switch has two black wires coming out of it. Before I started I checked
another receptacle on the same circuit to see what side the hot was on it is the right side. So
that is how I h...
Posted in thread: Sensor Switch on 11-19-2006 at 07:23 PM
Hello Again I just looked at the tester I talked about. And there is a discription of what each
light means. It was 1 red and 1 yellow it says HOT/GRD Reverse.Radioman
Posted in thread: Sensor Switch on 11-19-2006 at 12:36 PM
Thanks petey racerOkay so yesterday I put the receptacle box below ran 14/2 wire from the
sensor switch to receptacle hook everything up everything worked. But I took one of those
tester you plug in t...
Posted in thread: Sensor Switch on 11-19-2006 at 10:14 AM
The power comes in the box from the breaker from there its wired into the sensor switch. The
switch has a auto/on from there its goes to control three fluorescent light in each light it
has two tubes.
Posted in thread: Sensor Switch on 11-19-2006 at 09:22 AM
Hello AllI want to put a new plug in the wall below the sensor switch this sensor switch powers
three lights. There is no other source of power anywhere that I can the power from. Is it
possible to ge...
Posted in thread: Ceramic Tub Incloser on 09-21-2006 at 08:04 PM
Hello AllGetting back to the ceramic shower enclosure I have completed it I used the schluter
shower system for this project worked out great thanks for everybody input.Thanks AgainRadioman
- Possible mold problems??
- One Word Game
- drylocking basement and removing mold on concrete
- Garage door opener just barks at me!
- Fire Safety
- Your house is how old?
- Eliminating Drywall Ceiling In Attached Garage
- backyard improvements
- Dishwasher not draining completely
- Musky smelling rugs
- Getting rid of mosquitos
- Ice Maker not working
- Small cabin help..?
- Installing new garbage disposal
- Lawnmower Question