Last Activity:07-23-2015 2:30 PM
Likes Given: 1
4 Likes on 3 Posts
Posted in thread: Ice on bottom of Icemaker on 08-30-2015 at 12:53 PM
I had changed the Defrost Thermostat and tried again. It still had cycles of complete thawing
where it would go up to 60+ degrees. I then changed both Thermistors and since then it is
working fine, th...
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 04:36 PM
so do you think i should change the defrost thermostat?By the way, after it warmed up, it
immediately started cooling down again.
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 03:58 PM
this afternoon at your suggestion i put in a thermometer. It stayed around -6 all afternoon and
then suddenly it stopped cooling and went up to 58 degrees.The inside of the freezer walls are
wet, the ...
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 11:04 AM
how would the water leak make the sides of the freezer moist/wet to touch, it actually warms up
in there such that any condensation or ice melts and re-freezes.
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 09:41 AM
the defrost thermostat, is that the part described as the "thermistor"?
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 09:02 AM
Thanks Sparky.I had it off a couple weeks ago long enough for things to melt(more than they are
now) as i was replacing a water valve. Thats what you mean by "manual defrost"(turning it off
Posted in thread: Ice on bottom of Icemaker on 07-22-2015 at 06:48 AM
OK. I think i figured out what is going on here.My freezer goes through a cycle where it
defrosts/thaws and re-freezes. When this happens the ice gets stuck together when it freezes
again, and then th...
Posted in thread: Ice on bottom of Icemaker on 03-01-2015 at 04:11 PM
Hi have an HSM25gfta. I have noticed that the icemaker is only dispensing crushed ide. Now
while it might be the solenoid, i have moved the little plastic switch into the up position at
the back and i...
Posted in thread: Hotpoint Side by Side Water Dispenser running constantly on 06-17-2014 at 11:03 AM
OK, so here i am 2 years later and having a problem with the dispenser again.I have a Hotpoint
HSM25GFTA SA and here is the issue...I swapped in a new water filter last week. Since then
after getting ...
Posted in thread: Garage Door cables on sides on 03-02-2014 at 10:00 AM
hello. i have a double car garage door. I noticed today that one cable on the side is a little
frayed. I assume the chain on the top drives the steel rod to turn which in turn pulls the
cable up and t...