Last Activity:01-16-2008 7:11 PM
Posted in thread: 7.5 HP 80 gallon industrial 2 stage compressor on 01-17-2008 at 06:47 AM
Hi Folks: Thanks again for the advise.
Posted in thread: 7.5 HP 80 gallon industrial 2 stage compressor on 01-16-2008 at 12:04 PM
Hi:Porter-Cable CPLMC7580V2C 7.5 HP 80 gallon industrial 2 stage
compressor.Specs:Voltage/Hertz/Phase: 240/60/1 Horse Power: 11.00 peak, 7.5 run30 Amps @ 240
Volts.Instructions say "minimum branch cir...
Posted in thread: 2 post auto lift - 220v wiring on 01-11-2008 at 08:27 AM
Hi :Thanks for all the suggestions. I got a responce from the mfg.They said use the tan
conncted to motor body as gruond.Run the power to each terminal , one to L2 and one to L3.
Posted in thread: 2 post auto lift - 220v wiring on 01-10-2008 at 06:54 AM
Posted in thread: 2 post auto lift - 220v wiring on 01-09-2008 at 09:34 AM
Hi:It's single phase. At home useage.
Posted in thread: 2 post auto lift - 220v wiring on 01-08-2008 at 02:59 PM
a little more info...inside the switch box housing, the 2 wires from the motorgo to the top of
the switch. One goes to 4 T2, and the other goesto 6 T3. The wires I have to connect to come
off the top ...
Posted in thread: 2 post auto lift - 220v wiring on 01-07-2008 at 08:13 AM
I have a 2 post auto lift. On the motor plate it says: 3hp 220v 20 amps.There is also a safety
shut off switch on top if the car gets raise too high. The wires for the safety switch run down
Posted in thread: neutral bus, groud bus on 03-08-2007 at 01:48 PM
Hi:RE: "The neutral and ground bus are connected at the Main Panel only.If you install a panel
as an auxiliary, you need to keep the neutral and ground separate and carry them back to the
main panel t...
Posted in thread: neutral bus, groud bus on 03-08-2007 at 09:53 AM
Wondering about in the breaker panel..there are neutral busses and ground busses..Aren't these
bonded together? Wondering why the two,what the difference is, and how critical it is to wire
Posted in thread: 230v welder, 240v compresser - breaker & wire size? on 02-02-2007 at 03:50 PM
Hi Mr. Petey:Thanks so much.Yes, the compressor is 30 amps - running.