VIEW MY

Skeezix

Gift Premium Subscription To Skeezix

Join Date:

07-07-2011

Last Activity:

08-24-2011 10:37 AM

    ABOUT ME

  • Colorado

LATEST ACTIVITY

  • Posted in thread: Dryer wont dry clothes on 07-27-2011 at 06:12 PM
    What - no ideas? I've attached the schematic found on the inside of the back panel. I see the
    drum motor and the timer motor, but sure don't see the motor or anything else for that matter
    that turns t...

  • Posted in thread: Dryer wont dry clothes on 07-16-2011 at 10:45 PM
    The dryer is a Whirlpool LG7681XSW2.I did a load yesterday and instead of setting the
    temperature control to Heavy (hottest), I set it to Gentle (the coolest setting).It took just
    as long to dry when ...

  • Posted in thread: Fastener Question for Exterior Siding on 07-10-2011 at 12:06 AM
    My intent is to replace the lattice with something solid so that the wind, rain, and leaves
    won't blow into the deck area quite as much. The siding will extend to the floor of the deck.
    Two sections a...

  • Posted in thread: Fastener Question for Exterior Siding on 07-09-2011 at 11:50 PM
    I will first cut the plywood siding to size, then prime and paint all six surfaces, then
    install the siding, and finally touch up the staple heads and caulk the four edges. I was going
    to cover the st...

  • Posted in thread: Dryer wont dry clothes on 07-09-2011 at 11:37 PM
    No, it's not a stackable.I figure my problem has to be something that regulates the
    temperature, but I don't know how it's done. Could be either by varying the flame, or by
    switching it on and off. I ...

  • Posted in thread: Tape Measures on 07-07-2011 at 05:44 PM
    If anyone knows of a tape measure that won't disappear when the Better Half gets ahold of it,
    I'd sure like to know where I can get one.

  • Posted in thread: Fastener Question for Exterior Siding on 07-07-2011 at 05:35 PM
    thank you for replying.My first thought was to use #8 x 1-1/2 flathead screws, then I
    remembered I have a #18 stapler (1/4-inch crown) and a #16 stapler, both with beaucoup staples
    and brads.If you th...

  • Posted in thread: Fastener Question for Exterior Siding on 07-07-2011 at 04:28 PM
    My covered patio has a handrail around it. I would like to use 4x8x5/8" siding to keep the rain
    and snow from blowing in between the handrail and the floor. (I think this is referred to as a
    "knee wal...

  • Posted in thread: Dryer wont dry clothes on 07-07-2011 at 03:46 PM
    My gas dryer heats up but does not get very hot. Dryer vents to outside thru a 3-foot duct and
    has no lint buildup in the duct. What used to dry in a single 30- 45-minute cycle now takes at
    least an h...

0 COMMENTS
POST A COMMENT