Last Activity:07-26-2016 2:05 AM
Likes Given: 1289
764 Likes on 638 Posts
Posted in thread: Repairing loosen flagstone joint cracks – Polymeric Sand VS Mortar VS Envirobond? on 07-25-2016 at 07:53 PM
Looks like the slate was laid in cement. The pix aren't close enough for me to pick up any
detail about sand. Polymeric sand is not intended to be used under the stone. It is not a
substitute for a bo...
Posted in thread: Are you required to use water resistant sheetrock in a kitchen? on 07-25-2016 at 06:24 AM
I think the Op's other motive was to shout loudly about this guy. This thread will also serve
as a warning - to anyone who reads it - about being cautious when hiring.
Posted in thread: Hello on 07-24-2016 at 10:18 PM
Welcome Philsfog. There's always room here at the inn.:)
Posted in thread: B&D SPCM1936 cordless self-propelling electric mower stopped working on 07-24-2016 at 10:05 PM
the bottom of the page, there are links to the user manual and a link for repairs. Also a
bunch of reviews.So the mower will move under it's own power, but the blade is not spinning?
may be be a saf...
Posted in thread: sinking vent pipe on 07-24-2016 at 09:52 PM
If this is a vent pipe, and it exits the roof, you need to check that the rainproof seal is
Posted in thread: Cruiser Board Wood on 07-23-2016 at 07:49 PM
Don't think I'll be much help; I had to look up definition of a penny board:(
Posted in thread: Hellooo on 07-23-2016 at 01:07 PM
Tackle things one at a time and you will build on your knowledge. Ask many questions, and watch
the pros when you can. Welcome, and bring it on. We love a challenge.
Posted in thread: Plywood spacing on 07-23-2016 at 11:04 AM
Some screws just wouldn't countersink and just spun.Thread on some of those screws did not
extend all the way up to the head. The screws had too much reach. (Not sure if the terminology
Posted in thread: fig picking on 07-23-2016 at 07:37 AM
Kid learns a lesson, guys gets some work, Frodo gets the job done. Sounds like a good day.
Posted in thread: fig picking on 07-22-2016 at 10:01 PM