Speedo

LATEST ACTIVITY

• Posted in thread: Fireplace insert paint? on 01-17-2008 at 09:55 AM
  Thanks for the suggestions. I not only found heat resistant paint at HD, but I found it in
  brush-on. I got this to avoid the spray paint fumes inside the house. Thanks again for your
  help!Pete V

• Posted in thread: Fireplace insert paint? on 01-15-2008 at 09:20 AM
  I have a fireplace insert I'd like to put a new surround on, but before I put the surround on
  I'd like to make the metal insert look a little better. The face of the insert looks like it's
  got a baked...

• Posted in thread: Slab repair on 10-17-2007 at 02:02 PM
  Hello. I just had some plumbing work done underneath my home's concrete slab, where they had to
  break up the concrete, repair the pipes, and re-gravel and finish with concrete. I won't get
  into my opi...

• Posted in thread: Ventilation Fan Installation on 10-10-2007 at 07:45 PM
  Thanks. The box fan routine is what I'm doing now but I have 2 under 2 year olds and they are
  yankin on the cords. Thanks for the input I'll keep researching based on y'alls
  suggestions.Pete

• Posted in thread: Ventilation Fan Installation on 10-10-2007 at 11:50 AM
  I just did some measuring to address the ventilation question. I have 504ft2 of attic space and
  576in2 of open vents to the outside (2 x 268in2), so it sounds like I have sufficient
  ventilation. There...

• Posted in thread: Ventilation Fan Installation on 10-10-2007 at 10:06 AM
  Good info Glenn- thanks. I was also considering a whole house fan but I wasn't sure how that
  would work with respect to insulation in the wintertime. If I go that route I'll have to do
  some research o...

• Posted in thread: Ventilation Fan Installation on 10-10-2007 at 08:34 AM
  Hi- new to the forum here. I'd like to install a ventilation fan in my split level home in VA-
  mostly to expel the hotter air from the top floor into the non-climate controlled attic during
  the cooler...