StevenC

LATEST ACTIVITY

• Posted in thread: Frigidaire washer wont turn on? on 02-20-2012 at 12:34 PM
  My ohm meter has alligator clamps on it, so I went to plug the cord in and test it at the
  terminal instead to give me something to clamp too. As soon as I plugged it in to the wall the
  washer started ...

• Posted in thread: Frigidaire washer wont turn on? on 02-19-2012 at 05:08 PM
  What should I look for on the cord? It appears fine. I'll test the receptical when I get back
  home.If the receptical or cord was bad, why does the dryer still tumble? The breaker wasn't
  tripped either...

• Posted in thread: Frigidaire washer wont turn on? on 02-18-2012 at 09:16 PM
  The main breaker wasn't tripped. I haven't been able to locate the fuses, do they have them on
  older models? FLSE60RGS2 I haven't thought to check the voltage. Could the timer switch be bad?

• Posted in thread: Frigidaire washer wont turn on? on 02-18-2012 at 04:15 PM
  The other day my washer made a popping sound. I started investigating and found the terminal on
  the back where the power cord attaches to fried, so I replaced that. The washer was working
  intermittenl...

• Posted in thread: Sink drain leak? on 11-15-2011 at 07:52 PM
  Ok thanks! Also, the brass drain and the P trap don't line up, they're about 3/4" off (in every
  direction) because I'm using a standard P trap with a short sink. Right now I'm using the
  plastic flex d...

• Posted in thread: Sink drain leak? on 11-14-2011 at 04:25 PM
  Thanks for all the replies guys! I have plumbers putty rolled under the drain flange and sink
  basin already. I wasn't able to tackle the job yet as I've picked up a stomach virus. Redwood,
  so your say...

• Posted in thread: Sink drain leak? on 11-13-2011 at 07:48 PM
  After switching from a pvc to a brass drain and trying several different design washers I can't
  get the rubber mack washer to completely seal against the sink bottom. Water slowly begins
  dripping betw...

• Posted in thread: New valves leaking? on 09-18-2011 at 03:42 PM
  I have installed new cpvc and pvc sch 40 throughout the house. I installed new metal shut off
  valves on both lines under my bathroom sink, toilet and under my kitchen sink. Each valve was
  wrapped twic...

• Posted in thread: Installing new pvc from meter? on 07-01-2010 at 11:56 AM
  Ok I see, so how would you recommend connecting Cpvc to the galvanized outside the house?Thanks

• Posted in thread: Installing new pvc from meter? on 06-30-2010 at 02:36 PM
  Or are you saying to use pvc only for cold water throughout the house and Cpvc for the hot
  water? I'm aware but didn't specify.