VIEW MY

tk3000

Gift Premium Subscription To tk3000

Join Date:

10-27-2010

Last Activity:

07-24-2016 6:28 PM

Likes Given: 102

21 Likes on 19 Posts 

  • Columbus
  • OH

LATEST ACTIVITY

  • Posted in thread: Redo small deck roof to Support Walk-on and Panels on 07-22-2016 at 10:47 PM
    That would be the quick and easy way to get a slope, foam over plywood but 1% with 1" top end
    would run out at 100".The cheaper way would be just to lift the rafters at the top end. I am
    leaning towa...

  • Posted in thread: Redo small deck roof to Support Walk-on and Panels on 07-21-2016 at 06:43 PM
    How much would you like to raise the roof?That may be another conundrum... I believe that the
    minimum slope for a flat roof by building code here is 2%. (1/4" per 1'), the board length is
    about 12 ft ...

  • Posted in thread: Redo small deck roof to Support Walk-on and Panels on 07-18-2016 at 06:19 PM
    Why not shim on the underside of the rafters at the top? That way you can affect the pitch
    without creating gaps between the rafters and the sheathing.Hmm... You to change the level of
    the rafters whe...

  • Posted in thread: Redo small deck roof to Support Walk-on and Panels on 07-16-2016 at 11:15 AM
    slownstead: yeah, that would be lots of work especially with my tiny small table saw. I can cut
    a small board at an angle, but a 12ft lumber is not possible. To make things worse there are
    several 12f...

  • Posted in thread: Kitchen Subfloor repair on 07-14-2016 at 01:59 AM
    I think your job so far looks pretty good. all you can do is work with what you got and add
    blocking as required. Any patching I do without T&G edges I make surel I have support al the
    way around as y...

  • Posted in thread: Plywood spacing on 07-12-2016 at 11:26 PM
    1/8 on wall edges too? What about fastners in the field every 4 inches?Yeah, on wall edges the
    same gap applies. On the edges probably every 6 inches, and elsewhere (non-edge) about every
    12"

  • Posted in thread: Redo small deck roof to Support Walk-on and Panels on 07-12-2016 at 08:49 PM
    Where are you planning to put the shims??Well, I would rather have a continuous long shim add
    to the upper surface of the raters; or maybe planing a board to different thickness? At first,
    I was consi...

  • Posted in thread: Kitchen Subfloor repair on 07-12-2016 at 06:43 PM
    If you second sheet was going to overlap the first joint you would likely be fine.What you are
    trying to do is make the floor one big sheet that moves and bends as one.In this photo see
    where this guy...

  • Posted in thread: Kitchen Subfloor repair on 07-12-2016 at 03:19 PM
    I added some blocks perpendicular (and some boxes made out of 2x4s) to the joist in a spot
    where it seemed needed, but then simply adding block parallel to the joists (as shown in the
    pic) seemed to s...

  • Posted in thread: Kitchen Subfloor repair on 07-12-2016 at 01:35 PM
    Instead of me asking a bunch of questions Lets go with what would have done and you can see how
    close you are to that.Plywood sub floor are tongue and grove so when you walk on one board it
    does not b...

0 COMMENTS
POST A COMMENT