Last Activity:10-06-2008 6:30 AM
Posted in thread: Very Wierd Electrical Problem on 10-06-2008 at 07:04 AM
I think I found out what is going on. The meter that is mounted on the exterior of the house is
suppossed to have weep holes allowing the water to drain from the box if there is any mositure
in it. So...
Posted in thread: Very Wierd Electrical Problem on 10-06-2008 at 05:29 AM
I am workin in this house in the city of Rochester, I first got called to this customers house
because a duplex circuit on the second floor of his house went out. I trouble shooted the
circuit to be a...
Posted in thread: Basement Sink Pump: on 05-08-2008 at 05:45 AM
I just put a utility sink in my basement, it required the installation for a pump to force the
water out into the sewer. My main question is, do I have to install revent to an outside source
of air or...
Posted in thread: Half Post Question: on 05-08-2008 at 05:34 AM
I am putting a new railing in a house back in my town, it is going to require the installation
of a half post against a wall. My only question is, what type of fastener would you use to
attach the hal...
Posted in thread: Lightning Rods on 04-29-2008 at 09:41 AM
I am doing a roof over on a camp up in the Adirondaks. The roof is about 13 square. Not that
large. My only question that I have is, I want to put lightning rods on the roof because a few
years ago th...
Posted in thread: Crappy tools on 04-29-2008 at 09:34 AM
I agree with what everyone said, basically the parts that compose most of the expensive tools
like craftsman are the same parts that compose the cheap ones. The only difference with
craftsman is they ...
Posted in thread: any opinions of pull-out faucets? on 04-29-2008 at 09:29 AM
I am shopping for a new kitchen faucet and considering one of the new (popular?) ones where the
actual faucet head pulls out to act as a sprayer. I don't use a sprayer much but like to have
Posted in thread: Service Entrance on 04-07-2008 at 06:57 AM
I am doing over a small roof at my camp, about 15 square. The service entrance enters the house
on the roof with a 2 and a half inch pipe. The only problem I am running into is, I cannot
place a roof ...
Posted in thread: Resurfacing Concrete/cinder block walls on 03-13-2008 at 08:22 AM
Put a thin coat of mortar all over the bricks with a trowel then give it a little while to set
up then brush all the mortar. Wait to dry then paint.
Posted in thread: Stack Frost on 03-11-2008 at 09:03 AM
Put in a double wall pipe to keep the heat down
Common Sense Is a Great Thing to have.
- Floor Drain for AC Condensate Discharge
- Embedded Cleanout Covers
- Carrier HVAC - Fan not turning
- Can you tell me what it is called, please?
- Popping tiles
- Transistion problem
- Re attaching flagstone in walkway
- One Word Game
- What's that smell?
- Musky smelling rugs
- Builder's Joke Thread
- wiring thermostat
- Stucco Job
- Stainless Steel Fridge
- moisture from missing singles at roof peak?
- Shower pan