tonynace

LATEST ACTIVITY

• Posted in thread: Rough In for Microwave Vent on 11-26-2012 at 07:01 AM
  Hi,Vent should be the same on them all....venting up or out the back the vent is in the top
  middle or back middle.....microwave is 3&1/4" by 10". Might help.jeff.Thanks, I'll read
  through that.

• Posted in thread: Rough In for Microwave Vent on 11-24-2012 at 02:30 PM
  I'm installing an over the stove microwave during my kitchen remodel and want to vent it to the
  outside to better remove cooking odors and smoke. I have not chosen one yet as I haven't had
  the time to...

• Posted in thread: Cabinet Trim Problem on 09-06-2011 at 04:27 PM
  There is one other option. Start your first cabinet slightly out of plumb/level. Not enough
  that it is visible to the naked eye, but leaning towards the line on your level. This will let
  each one of y...

• Posted in thread: Cabinet Trim Problem on 09-06-2011 at 08:55 AM
  Maybe you could add a 1/2" or 3/4" thick board to you ceiling. Use a router to create an edge
  and stain it the color of your crown. Let it hang out just past your crown to add yet another
  dimension to...

• Posted in thread: Cabinet Trim Problem on 09-03-2011 at 08:04 AM
  I've installed my upper cabinets on one side of my kitchen. They are level, but I noticed when
  I got down to the other end from where I started, that I had a bigger gap between the top of
  the cabinets...

• Posted in thread: Cabinet Fastening on 08-25-2011 at 07:23 AM
  They don't need to be fastened to the floor?

• Posted in thread: Cabinet Fastening on 08-25-2011 at 05:59 AM
  Where should base cabinets be fastened? I'm putting them over tile. I know I fasten them
  together, but do they then get fastened to the floor, wall, or both?