tractng

LATEST ACTIVITY

• Posted in thread: Black paint on 01-02-2013 at 04:28 PM
  I am cleaning the garage and have many left over gallons of paint. Most paint gallons are
  latex. I am thinking of bringing to Home Depot and ask them to make them black. Is this doable
  in terms of wan...

• Posted in thread: Looking to drill holes through tiles on 11-25-2012 at 11:33 PM
  i would use a carbide tip drill bit. the same used for drilling through concrete will work. i
  did this many times and used a piece of masking tape over the spot and made a small chip with a
  black dryw...

• Posted in thread: Looking to drill holes through tiles on 11-25-2012 at 11:04 AM
  I want to install a handle in the bath tub area. Many attempts of using a suction handles
  failed.What tip of drill do I need? I am not sure if this is ceramic or porcelain tile. It has
  been a few year...

• Posted in thread: Turbine vent on 11-22-2012 at 01:08 PM
  Thank guys. I installed on the garage the other day with the whirlybird. I sort of watched the
  wrong video. Instead of slitting (shingles) both sides of the base to the bottom edge, I only
  did a littl...

• Posted in thread: Turbine vent on 11-20-2012 at 10:21 AM
  I am planning to install a turbine vent on my garage today. What is the idea placement for such
  vent. I am thinking it has to be near the highest peak of the roof top and somewhat less
  visible to the ...

• Posted in thread: FIP connect to PVC on 08-24-2012 at 03:39 PM
  Trying to fix a leak on the low drain line of my travel trailer.I bought a connector piece (one
  end is pex slip on and the other is FIP). Can I use a cap made of PVC to connect to the PVC?
  PVC is chea...

• Posted in thread: Plastex and loctite on 07-17-2012 at 01:28 PM
  I'm 100% sure it's not going to work.I tryed that exact material, with the same adhesive on a
  very slightly curved roof on a pump house a customer had made out of sanded plywood.It just
  would not stay...

• Posted in thread: Plastex and loctite on 07-16-2012 at 11:20 AM
  Guys,Looking to put up a 35" x 80" plas-tex polywall inside my trailer (replacing wallpaper).
  Half of the sheet will be on the wall and the other half is on the ceiling (curves up). Below
  is the link ...

• Posted in thread: Cutting luan board on 06-30-2012 at 06:23 PM
  Circular saw set to 1/8" depth.Should I tape the line first so it won't chip when I cut?

• Posted in thread: Cutting luan board on 06-30-2012 at 11:52 AM
  Guys,Trying to cut a bad piece of a luan board with laminiating fiberglass sheet (cutting
  horizontal about 7ft wide). Right now that piece is part of my front wall of my travel trailer.
  Below the shee...