trigg

LATEST ACTIVITY

• Posted in thread: grounding on 12-02-2012 at 05:32 PM
  Thanks for the info.It is all copper and meter is outside home .There are shark fittings at
  regulator (not sure yet if that is a factor since its got plastic inside).I will check w meter.
  tommorrow. w...

• Posted in thread: grounding on 12-02-2012 at 01:59 PM
  I have a GEC ground going to the copper pipe at entrance of home (4ft from where pipe enters)
  and then AFTER the ground on the same pipe is a pressure regulator then it goes to water
  heater.Do i need ...

• Posted in thread: panel/grounded on 11-20-2012 at 05:49 PM
  Hi thanks for the info.I went ahead and bonded the box in both areas(neutral bar screw and
  jumper) and secured the aluminum to copper pipe connection for grounding(with anti corrosion on
  it)..Had to u...

• Posted in thread: attic heat on 11-13-2012 at 07:44 PM
  Had wanted to install a in wall gas heater in attic but wasnt sure the specs/requirements.I
  already have one in the room below and was going to install a T with shutoff then run line to
  attic heater.A...

• Posted in thread: panel/grounded on 11-11-2012 at 12:06 PM
  this will tell me if the box is bonded?

• Posted in thread: panel/grounded on 11-10-2012 at 09:15 PM
  Yes I do...

• Posted in thread: panel/grounded on 11-04-2012 at 10:10 PM
  im trying to see if my panel is grounded and bonded ,have added a circuit and didnt see the
  bonding screw.It has a silver ground going from neutral bar to copper pipe(but is 25 ft
  away).Any info is ap...