Last Activity:01-02-2008 10:21 PM
Posted in thread: Low water faucet flow on 09-17-2006 at 05:15 PM
I just had a hot water heater replaced, I tried just replacing the thermal coupler as suggested
on this site. (It was a nice try!) Anyway, all of my faucets are flowing fine except for one
Posted in thread: Plumbing Help Needed on 06-08-2006 at 03:27 PM
The bathtub drains normally. This full bath shares a wall with a 1/2 bath in which that sink
drains fine. Today I purchased a device to place on the end of my garden hose to place in the
wall pipe and...
Posted in thread: Plumbing Help Needed on 06-08-2006 at 09:44 AM
Thanks I did manage to accomplish that. And it appears to be working. However my new challenge
is the water leaking at the joining points between the p-trap and the extender and to the sink.
It's as t...
Posted in thread: Plumbing Help Needed on 06-07-2006 at 07:54 AM
Thanks to all for your words of wisdom. After reaching inside the wall I could feel another
"seam" but no threading. I'm afraid to use the wrench since the first set of piping I removed
riped apart. I...
Posted in thread: Plumbing Help Needed on 06-03-2006 at 09:08 AM
The pipe is thicker and heavier than the extension piece and previous trap that was originally
attached. Really heavy looking though no. Wish me luck I have the coarse sandpaper on hand and
I'm ready ...
Posted in thread: Plumbing Help Needed on 06-02-2006 at 08:13 AM
Glenn, thanks for your help. Of course you always start out doing one task and end up with
more. The pipe from the wall has only about 2-3 inches exposed. Sounds like I need to cut away
the drywall to...
Posted in thread: Plumbing Help Needed on 06-01-2006 at 07:31 AM
Thank you for the info. It is a galvanized pipe for a drain line. I'll look for the transition
adapter and try cleaning the pipe once again.Appreciate the help.
Posted in thread: Plumbing Help Needed on 05-31-2006 at 07:35 PM
AS my screen indicates I'm a rookie. In trying to remove my bathroom sink the metal piping
melted in my hand from hard water silt. I'm trying to replace the piping and was told that I
could connect ne...