vikasintl

LATEST ACTIVITY

• Posted in thread: What type of spray gun I should buy to use with air compressor on 09-25-2012 at 07:13 PM
  I am looking at harbor freight website to buy a spray gun to paint exterior on shed in
  backyard.the paint is latex .....I have a hausfed brand 2 hp air compressor which has 2
  tanks..Am not sure if I s...

• Posted in thread: Is it possible to check baseboard heater without supply wires and thermostat? on 09-25-2012 at 06:48 PM
  Ok thanks...the other heater wire which is in wireway it shows continuity but the reading is
  only 0.06 at 200 ohms setting...is this ok? or something is wrong?

• Posted in thread: Is it possible to check baseboard heater without supply wires and thermostat? on 09-23-2012 at 01:21 PM
  If there is heater element continuity then checking either end of the heater to ground is
  enough.If you know the heater rated voltage and rated power in watts then the element hot
  resistance is (V^2)/...

• Posted in thread: Is it possible to check baseboard heater without supply wires and thermostat? on 09-21-2012 at 01:52 PM
  Clarification...which two wires I should check ? two wires from the heater means one element
  wire and other wire in wireway or one end of element to other end of element?also how which
  line I should c...

• Posted in thread: Is it possible to check baseboard heater without supply wires and thermostat? on 09-21-2012 at 01:33 PM
  Without connecting thermostat or supply wires..how can I just check the heater if its
  working... ...is there any way we can check using ohmmeter ...(resistance)...if yes...please
  explain how...if its ...

• Posted in thread: How to I connect double thermostat on right side...withtout supply wires on 09-21-2012 at 11:51 AM
  On right side there are not supply wires in my case...so...one element wire and one wire from
  heater wireway...only two wires....right now they both are connected with wirenut....so if I
  want to insta...

• Posted in thread: Roof and wall sheathing on 07-19-2012 at 01:21 PM
  Ok one more question...the lower wall should also have two top plates and one bottom plate
  ..total 3 plates?

• Posted in thread: Roof and wall sheathing on 07-07-2012 at 02:19 AM
  Ok thanks a lot..

• Posted in thread: Roof and wall sheathing on 07-05-2012 at 04:39 PM
  Well, I already have 8 feet 2x4s so I would use them so it would be 96" instead 97" which is ok
  if its one inch lower...its fine...I have to adjust one and half inch for double top plate any
  way.........

• Posted in thread: Roof and wall sheathing on 07-05-2012 at 09:56 AM
  Ok I can use two top plates but rest of the measurements is correct as I shown above?also I did
  not understand what you meant 107" ..so I dont have to buy 10 feet...please explain?