VIEW MY

woodchuck

Gift Premium Subscription To woodchuck

Join Date:

07-19-2008

Last Activity:

09-19-2017 11:29 PM

26 Likes on 22 Posts 

    ABOUT ME

  • diy
  • chuck
  • Tuscaloosa
  • Al

LATEST ACTIVITY

  • Posted in thread: Noisy fridge problem on 09-20-2017 at 07:54 AM
    It's probably the starter solenoid and if it's external it can be replaced. It's located where
    the wires go to the compressor.

  • Posted in thread: Noisy fridge problem on 09-19-2017 at 05:19 PM
    You should be able to tell if its the fan by the compressor. Un plug the fan to see if the
    noise stops when the fan stops. If not , it could be the evaporator fan in the freezer. If ice
    builds up beca...

  • Posted in thread: Kenmore Elite Side by Side Ice-Maker on 09-13-2017 at 07:14 PM
    The ice maker shut off arm has to make a switch inside the housing to work the water valve.
    Something could be loose or you may can slightly bend it to make it work. If you bend it too
    much it won't t...

  • Posted in thread: Low water pressure on 08-28-2017 at 08:24 PM
    if you determine you have low pressure from the supplier and they can't raise it, you can put a
    shallow well pump in line to boost your pressure. I used one for years until the water system
    was able t...

  • Posted in thread: Kenmore Coldspot 106.54596400: freezer/fridge divider hot to the touch on 08-27-2017 at 11:47 AM
    The air flow is for this problem is the air flow under the fridge where the evaporator coils
    are. They get covered with dust and animal hair. Hard to reach but with compressed air or cloth
    on a stick ...

  • Posted in thread: Kenmore Coldspot 106.54596400: freezer/fridge divider hot to the touch on 08-24-2017 at 09:36 PM
    Normal warmth is created by the automatic energy saver system circulating warm liquid around
    the front edge of the of the freezer compartment (area between the doors) to help prevent
    condensation on t...

  • Posted in thread: Kenmore Coldspot 106.54596400: Water on the bottom of the freezer on 05-15-2017 at 09:41 AM
    Put air pressure and blow out the tube. The lower end under the unit gets blocked with dust,
    and hair etc. Could be mildew. After you blow it out, pour water through it to make sure it
    drains away qui...

  • Posted in thread: Do I need to replace the water inlet valve? on 11-03-2016 at 09:27 AM
    Swap the water lines on the inlet valve and press water dispenser to see if the water goes into
    the icemaker. Swap the wires on water inlet valve to see if ice maker calls for water when it
    dumps the ...

  • Posted in thread: exhaust fan vertical wall mount on 01-29-2016 at 05:34 PM
    I have gone to an appliance parts store and bought a replacement motor. Take the old motor out
    for them to see.

  • Posted in thread: Cleaning an Outdoor Glass Table Top on 08-17-2015 at 09:02 AM
    I have two on my wooden pool deck under a nice shade tree. I tilt both tables on their side
    when not being used. Quick and easy to set upright. They stay clean as a whistle.

0 COMMENTS
POST A COMMENT


Newest Threads