- Posts 21
Last Activity:03-11-2006 1:13 AM
Posted in thread: anyone purchase a steelmaster building? on 03-11-2006 at 12:14 AM
They show a picture of my local Hummer dealership.It actually looks better in person than in
Posted in thread: Trane XE 90 pressure switch on 02-25-2006 at 12:39 PM
Yup, seen plenty of vents that where per manufactures specs 2" and well over 35 feet. Brand has
much to do with it. A 40,000 btu furnace could have a vent pipe 2" dia and 60 feet equivelant
Posted in thread: Installing copper pipe on 02-25-2006 at 10:16 AM
I did this Job on my house before i knew what i was doing-about five years ago.Started at 8 in
the morning and finnished at 11pm.Only thing i would do different is to not cut off the 3/4
flare where i...
Posted in thread: Trane XE 90 pressure switch on 02-25-2006 at 10:00 AM
It sounds a lot like two problems to me.It could almost anything associated with the drain,
flue, inducer motor, pressure switch.Well step one at this point would be to replace the
pressure switch now...
Posted in thread: Adding insulation to finished walls, foam or blow in? on 02-22-2006 at 06:23 PM
Thanks for the information.Makes sense to me.Foam is not used to much in this area of the
country, but i understand it is getting more common.I take it the stuff that they put in
existing walls is dif...
Posted in thread: Lack of Gas Hot Water on 02-21-2006 at 09:23 PM
There is a little brain teaser in The original posters post.How much water does the tub
hold?How long does it take for a 75 gallon water heater to recover? Ten minutes?How much volume
does all the pip...
Posted in thread: Lack of Gas Hot Water on 02-21-2006 at 09:15 PM
Ive had this problem before where one bathroom would get hot water just fine and another would
never quite get hot water.My brain hurts trying to remember all the details.There was a
Posted in thread: I think I'm in trouble:-( on 02-21-2006 at 08:53 PM
The cross hair peice just keeps stuff from going down the drain and functioned to screw the
thing together when first installed.If you have a grate or something above the crosshair dealy
then it seams...
Posted in thread: Adding insulation to finished walls, foam or blow in? on 02-21-2006 at 12:57 PM
I could be wrong but.A newer house comes with tyvek or some sort of barrier to
wind/infiltration on the out side of the house.A older house is probably not as tight as a new
one because they used tar ...
Posted in thread: Outlets Grounded??? on 01-28-2006 at 06:18 PM
I've been told im nuts.As i get to each room i've been tearing out all the dry wall, putting up
a thicker wall and reinsulating every thing. I also am rewiring it all to make it modern and
- Toilet will not fill
- soffit vent ?
- Suggestions on how to repair
- Aggressive Deer
- Attaching wood post to concrete slab
- Fire Safety
- One Word Game
- Driveway Resurfacing
- Lennox A/C isn't cooling
- Eliminating Drywall Ceiling In Attached Garage
- Garage door opener just barks at me!
- Crumbling, 'spaling' exterior foundation walls
- Getting rid of mosquitos
- Possible mold problems??
- drylocking basement and removing mold on concrete