VIEW MY

zepper

Member

Gift Premium Subscription To zepper

Join Date:

10-13-2009

Last Activity:

09-18-2017 9:26 AM

10 Likes on 10 Posts 

    ABOUT ME

  • Many
  • Withheld by request
  • vancouver, bc

LATEST ACTIVITY

  • Posted in thread: Truly round baseboard corners? on 09-01-2017 at 02:22 AM
    Haha no we like a little salacious content now and again. Appeal to her monetary side and tell
    her you want to buy a wood lathe and table saw and a half dozen other woodworking tools so you
    can make t...

  • Posted in thread: Truly round baseboard corners? on 08-31-2017 at 04:41 PM
    OK, I just had a nice chat with Neil at the Corner Block Store. (Talk about a specialty, huh?)
    He's a heck of a nice guy. That looks like the best way to go, as he'll do the whole profile
    including th...

  • Posted in thread: Truly round baseboard corners? on 08-31-2017 at 04:15 PM
    Thanks for your replies, guys.They should sell the piece you need but if not there are places
    that will make what you need. Or do the 22.5 cut like Neil suggested. for the link, Bud. I
    see I could g...

  • Posted in thread: Truly round baseboard corners? on 08-30-2017 at 11:58 PM
    Hey guys,Now that I have our new floor in, I'm ready to install our new baseboards. The molding
    I'm using has this profile:https://s26.postimg.org/km015xsnd/moulding_profile.png(We have some
    unusually...

  • Posted in thread: Removing odd shelf brackets? on 08-13-2017 at 04:56 AM
    Right you were! The nut-like object is a spring clip you can press with a small flat-blade
    driver to release the bracket. So it functions like the traditional hex bolt, but when you
    install, you just ...

  • Posted in thread: Removing odd shelf brackets? on 08-11-2017 at 08:54 PM
    Hey guys,Have any of you ever seen brackets like these? They're from a small glass shelf I'm
    removing in one of our bathrooms. I can't figure out how they're attached. Rather than the
    usual hex screw ...

  • Posted in thread: Dishwasher drain hose slightly too big... on 03-21-2017 at 02:08 AM
    You were right! I was so focused on the end of the hose, I didn't realize the last segment was
    actually an adapter that'd been added for the previous, larger "Y", attached by the two upper
    clamps over...

  • Posted in thread: Dishwasher drain hose slightly too big... on 03-20-2017 at 11:27 PM
    Hey guys – I've just installed a new kitchen sink. Unfortunately, I didn't notice that the
    dishwasher drain "Y" connector the guy at the hardware store gave was about 1/8" too small for
    our hose, and ...

  • Posted in thread: Tricky floorplan—where do I start? on 01-05-2017 at 04:17 PM
    Hey guys—thanks for your extra input on this, I really appreciate it.[re spline] Most times
    people cut [their] own, you could cut one side of flooring for that, you will likely be cutting
    at the walls...

  • Posted in thread: Tricky floorplan—where do I start? on 01-04-2017 at 11:43 PM
    I asked about this on one other forum. They recommended I install the first row along the hall
    wall, snap a chalk line even with that through the width of the house, then screw down
    scrap-wood guides ...

0 COMMENTS
POST A COMMENT