DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 10 of 10
Search took 0.01 seconds. Search: Posts Made By: ozone
DIY Home Repair Forum: HVAC 02-26-2013, 06:35 AM
Replies: 11
Views: 1,921
Posted By ozone
Good replies that I would totally agree with,...

Good replies that I would totally agree with, especially the damage that can be done from icicles and ice slides off the roof. One issue not mentioned is that when a full cover is used it not only...
DIY Home Repair Forum: HVAC 01-04-2013, 06:26 AM
Replies: 12
Views: 797
Posted By ozone
Yes, that is the collector box. When you install...

Yes, that is the collector box. When you install the new one you should be using high temperature red silicone caulk to get a moisture/pressure seal. If you damaged your inducer gasket when you...
DIY Home Repair Forum: HVAC 01-03-2013, 09:32 AM
Replies: 12
Views: 797
Posted By ozone
Regarding your question in post #8. If your...

Regarding your question in post #8.
If your refering to the plastic cover between the lower area of the heat exchanger and the inducer, (combustion fan). Then you are refering to the "collector box".
DIY Home Repair Forum: Plumbing Forum 12-19-2012, 09:19 AM
Replies: 4
Views: 663
Posted By ozone
As mentioned above, rust is a natural occurance...

As mentioned above, rust is a natural occurance for cast iron that is not a problem. If your issue with it is appearance then you could try a product/chemical called "ospho". I have used it many...
DIY Home Repair Forum: HVAC 12-07-2012, 06:48 PM
Replies: 8
Views: 420
Posted By ozone
I know that zip screwing it in will work fine,...

I know that zip screwing it in will work fine, but if clips are what you want you may find the correct interchangable ones at this, or another such link:...
DIY Home Repair Forum: HVAC 12-07-2012, 08:46 AM
Replies: 8
Views: 420
Posted By ozone
I think in time all those plastic door clips...

I think in time all those plastic door clips become brittle and easily break. Occasionally you luck out and the door has four clips and only the top two are used/needed as the bottom is held in...
DIY Home Repair Forum: HVAC 04-21-2012, 10:18 AM
Replies: 4
Views: 323
Posted By ozone
I must admit having only experience in the...

I must admit having only experience in the installation of split, mini-split, and the normally placed window AC system. With that in mind I can't speak with familiarity to all the issues that a...
DIY Home Repair Forum: Plumbing Forum 04-04-2012, 03:36 PM
Replies: 6
Views: 343
Posted By ozone
You state the majority of the home is serviced by...

You state the majority of the home is serviced by a hot water system. By chance do you have a secondary forced-air system with a humidifier? If so they are usually plumbed to the hot water supply...
DIY Home Repair Forum: HVAC 09-10-2011, 07:39 AM
Replies: 1
Views: 734
Posted By ozone
6% is the same as .06, so 7.5 X .06 = .45. Your...

6% is the same as .06, so 7.5 X .06 = .45. Your -/+ tolerance would be 7.05 to 7.95. If you carry a cell phone you can use the "Tip Calculator" tool. $7.50 meal, 6% tip = $.45.
DIY Home Repair Forum: HVAC 09-01-2011, 05:33 AM
Replies: 4
Views: 905
Posted By ozone
You have established that high and low voltage...

You have established that high and low voltage are present at the outside unit, good start. I have addressed and corrected the same problem a few times in the last month. Contactor -you replaced-. ...
Showing results 1 to 10 of 10

 

Newest Threads

FOLLOW US ON