DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: trigg
DIY Home Repair Forum: Electrical and Wiring 12-02-2012, 05:32 PM
Replies: 4
Views: 502
Posted By trigg
Thanks for the info.It is all copper and meter is...

Thanks for the info.It is all copper and meter is outside home .There are shark fittings at regulator (not sure yet if that is a factor since its got plastic inside).I will check w meter. tommorrow....
DIY Home Repair Forum: Electrical and Wiring 12-02-2012, 01:59 PM
Replies: 4
Views: 502
Posted By trigg
grounding

I have a GEC ground going to the copper pipe at entrance of home (4ft from where pipe enters) and then AFTER the ground on the same pipe is a pressure regulator then it goes to water heater.Do i...
DIY Home Repair Forum: Electrical and Wiring 11-20-2012, 05:49 PM
Replies: 6
Views: 928
Posted By trigg
Hi thanks for the info.I went ahead and bonded...

Hi thanks for the info.I went ahead and bonded the box in both areas(neutral bar screw and jumper) and secured the aluminum to copper pipe connection for grounding(with anti corrosion on it).
.Had...
DIY Home Repair Forum: HVAC 11-13-2012, 07:44 PM
Replies: 1
Views: 660
Posted By trigg
attic heat

Had wanted to install a in wall gas heater in attic but wasnt sure the specs/requirements
.I already have one in the room below and was going to install a T with shutoff then run line to attic...
DIY Home Repair Forum: Electrical and Wiring 11-11-2012, 12:06 PM
Replies: 6
Views: 928
Posted By trigg
this will tell me if the box is bonded?

this will tell me if the box is bonded?
DIY Home Repair Forum: Electrical and Wiring 11-10-2012, 09:15 PM
Replies: 6
Views: 928
Posted By trigg
Yes I do...

Yes I do...
DIY Home Repair Forum: Electrical and Wiring 11-04-2012, 10:10 PM
Replies: 6
Views: 928
Posted By trigg
panel/grounded

im trying to see if my panel is grounded and bonded ,have added a circuit and didnt see the bonding screw.It has a silver ground going from neutral bar to copper pipe(but is 25 ft away).
Any info...
Showing results 1 to 7 of 7