DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 13 of 13
Search took 0.02 seconds. Search: Posts Made By: kentannenbaum
DIY Home Repair Forum: HVAC 05-02-2012, 04:44 AM
Replies: 4
Views: 333
Posted By kentannenbaum
Hey Steve, didn't want to leave you hanging. ...

Hey Steve, didn't want to leave you hanging. Actually, it hasn't happened...yet. The is at a house we use on weekends and occasionally rent out. It hasn't happened yet because our experience is...
DIY Home Repair Forum: HVAC 04-20-2012, 07:13 AM
Replies: 4
Views: 333
Posted By kentannenbaum
For those of you who've checked this out, I'm...

For those of you who've checked this out, I'm proceeding with the doing it. I've thought about it carefully; since the A/C vents to the outside and cutting through the exterior wall is not a...
DIY Home Repair Forum: HVAC 04-18-2012, 01:07 PM
Replies: 4
Views: 333
Posted By kentannenbaum
A/C placement

I've got a typical enclosed space under a staircase adjacent to our living room. There's a full sized door to the space. I'd like to cut into the outside wall of the house and place an A/C in a...
DIY Home Repair Forum: Framing and Foundation 04-13-2011, 09:28 AM
Replies: 2
Views: 782
Posted By kentannenbaum
post question

I added a 4 x 18 deck to an existing screened porch that's been attached to my house for many years. I used three 16x16x10 cement blocks in the corners and center on which the new double 2x6 sill...
DIY Home Repair Forum: Electrical and Wiring 01-28-2011, 04:59 AM
Replies: 6
Views: 1,923
Posted By kentannenbaum
Actually, I decided to run another separate line...

Actually, I decided to run another separate line for the A/C. Thanks very much for the insight.
DIY Home Repair Forum: Electrical and Wiring 12-27-2010, 02:49 PM
Replies: 6
Views: 1,923
Posted By kentannenbaum
This is a 12/3 cable. My plan for the 120v A/C...

This is a 12/3 cable. My plan for the 120v A/C WAS to use the white wire as neutral and of course the copper as ground AND to use the SPDT to split one of the hot wires which goes to the baseboards...
DIY Home Repair Forum: Electrical and Wiring 12-27-2010, 08:29 AM
Replies: 6
Views: 1,923
Posted By kentannenbaum
single-pole double-throw switch

I just ran a 12-3 line for 240v baseboard heaters and now want to use one of those lines for an A/C in the same room during the summer. The switch is really expensive, but is there anything wrong...
DIY Home Repair Forum: Electrical and Wiring 12-21-2010, 04:52 AM
Replies: 2
Views: 1,300
Posted By kentannenbaum
Hey, thank you.....no need to fry.

Hey, thank you.....no need to fry.
DIY Home Repair Forum: Electrical and Wiring 12-20-2010, 07:17 AM
Replies: 2
Views: 1,300
Posted By kentannenbaum
single vs double pole for 240v

I recently installed two 240v baseboards in series with a 240v double-pole
wall thermostat. Today I saw a 240v heater that says it uses a single-pole TS.
I'm doing the same thing in another room...
DIY Home Repair Forum: Roofing and Siding 10-31-2010, 05:29 PM
Replies: 5
Views: 1,563
Posted By kentannenbaum
Hey....thanks for the advice.

Hey....thanks for the advice.
DIY Home Repair Forum: Electrical and Wiring 10-31-2010, 05:27 PM
Replies: 11
Views: 4,202
Posted By kentannenbaum
It's the main service panel...thanks for the...

It's the main service panel...thanks for the advice.
DIY Home Repair Forum: Roofing and Siding 10-31-2010, 01:18 PM
Replies: 5
Views: 1,563
Posted By kentannenbaum
shed roof material

I've got a old 8 x 20 shed with a flat roof in good shape except the old tar paper is pretty beat and leaks in one place. I saw a roll of material that's crack and peel water proofing and was told...
DIY Home Repair Forum: Electrical and Wiring 10-31-2010, 01:11 PM
Replies: 11
Views: 4,202
Posted By kentannenbaum
neutrals and grounds on same bar

I moved into an older home that seems wired fine, ample power and no problems. However, I noticed the grounding bar in the panel has both the ground and neutral wires attached to it. I read...
Showing results 1 to 13 of 13

 

Newest Threads

FOLLOW US ON