DIY Home Improvement, Remodeling & Repair Forum
>
Search Forums
> Search Results
Go to Page...
Page 1 of 3
1
2
3
>
Showing results 1 to 25 of 54
Search took
0.01
seconds.
Search:
Posts Made By:
Jdmrenovations
DIY Home Repair Forum:
Painting Forum
02-19-2012, 11:33 AM
Replies:
3
Primer mistake!
Views:
490
Posted By
Jdmrenovations
What type of paints are involved? Interior or...
What type of paints are involved? Interior or exterior, latex or oil? Inadvertently mixing and matching the two can cause problems at times, but it's less common with modern paints.
DIY Home Repair Forum:
General Chit-Chat
02-19-2012, 11:22 AM
Replies:
27
What is the best way to quit smoking?
Views:
1,335
Posted By
Jdmrenovations
One thing you must do is look at your normal...
One thing you must do is look at your normal routine and identify your "problem" times. I used to drive 2 hrs to and from work every day down in DC, and it didn't take me long to realize that a good...
DIY Home Repair Forum:
General Home Improvement Discussion
02-19-2012, 11:10 AM
Replies:
6
HELP hiding gap!
Views:
1,211
Posted By
Jdmrenovations
An outside corner over the existing bulkhead...
An outside corner over the existing bulkhead corner would be the fix for me, even if I had to make the moulding myself out of a few pieces of standard OG base trim.
DIY Home Repair Forum:
Flooring
02-19-2012, 11:03 AM
Replies:
5
Ceramic tile floor squeaks after roof leak
Views:
653
Posted By
Jdmrenovations
What type of screws, was it glued, etc are all...
What type of screws, was it glued, etc are all big questions. The gap needed to cause a squeak is sometimes so small you can't even see it move while staring directly at it. Speaking of staring at...
DIY Home Repair Forum:
Decorating and Design
01-25-2012, 05:50 PM
Replies:
19
Poll:
Opinions on Remodel Design.
Views:
2,703
Posted By
Jdmrenovations
Neal is dead on with the arches...they are tough...
Neal is dead on with the arches...they are tough to get right. First the openings need to be roughly the same size...they just look better that way. Everyone will naturally look at them...then...
DIY Home Repair Forum:
Framing and Foundation
01-25-2012, 05:43 PM
Replies:
33
Sagging 2nd Story Floor After Main Floor Load-Bearing Wall Altered Below
Views:
5,346
Posted By
Jdmrenovations
My :2cents: can sort of be summed up in my...
My :2cents: can sort of be summed up in my signature line.
Definitely get a qualified engineer on it asap. Just reading through this thread made me nervous and angry at the same time
Good...
DIY Home Repair Forum:
General Chit-Chat
01-25-2012, 05:28 PM
Replies:
80
Whats The Price of Unleaded Gas Where You Are?
Views:
2,216
Posted By
Jdmrenovations
Holding in the $3.50 range. On another...
Holding in the $3.50 range.
On another note, I just heard on the radio today that our esteemed Governor is now going to introduce legislation to raise the gas tax by 30 cents, not the previously...
DIY Home Repair Forum:
General Chit-Chat
01-25-2012, 05:19 PM
Replies:
22
Resolutions
Views:
831
Posted By
Jdmrenovations
Believe me, I am doing more exercise now than I...
Believe me, I am doing more exercise now than I ever did...all aimed at my core and back muscles.
I don't necessarily need to STOP working in the field, I just need to stop working STUPID in the...
DIY Home Repair Forum:
General Home Improvement Discussion
01-18-2012, 05:49 PM
Replies:
8
Tiling a backsplash
Views:
1,321
Posted By
Jdmrenovations
Yeah, pre-mixed grout in a bag gives me the...
Yeah, pre-mixed grout in a bag gives me the willies...lol.
DIY Home Repair Forum:
General Chit-Chat
01-18-2012, 05:08 PM
Replies:
22
Resolutions
Views:
831
Posted By
Jdmrenovations
Especially in this economy, where keeping the...
Especially in this economy, where keeping the tool belt off is tougher than ever. When it was booming, I did more on the phone in my office (truck).
Now........someone's gotta do it right.
DIY Home Repair Forum:
Painting Forum
01-17-2012, 10:53 AM
Replies:
9
Finishing basement
Views:
1,212
Posted By
Jdmrenovations
Yeah, the prep would be the tough part. Ductwork...
Yeah, the prep would be the tough part. Ductwork is normally galvanized, has to have the oil stripped off of it in order for paint to stick.
Other parts would have similar issues.
Got a pic of...
DIY Home Repair Forum:
Windows and Doors
01-17-2012, 10:50 AM
Replies:
16
Replacement windows
Views:
1,538
Posted By
Jdmrenovations
At least around here, replacement window...
At least around here, replacement window installation "specialists" run around largely un-regulated and un-watched. They tear out the old from outside, install the new behind the casing, look at the...
DIY Home Repair Forum:
General Home Improvement Discussion
01-17-2012, 10:31 AM
Replies:
5
Central Heating System Smells!!!
Views:
1,049
Posted By
Jdmrenovations
Would duct cleaning take care of that sort of...
Would duct cleaning take care of that sort of thing? I know it's aimed at dust mainly...but maybe the cause of the smell is sticking to the crud in the ductwork??
DIY Home Repair Forum:
General Chit-Chat
01-17-2012, 10:28 AM
Replies:
22
Resolutions
Views:
831
Posted By
Jdmrenovations
All of last summer was spent in a chiropractor's...
All of last summer was spent in a chiropractor's office, tending to 2 bad disks in my lower back...L3 and L4 area I believe. Now that I can walk again and not be in constant pain, my resolution...
DIY Home Repair Forum:
Walls and Ceilings
01-17-2012, 10:22 AM
Replies:
5
Question about removing some walls
Views:
513
Posted By
Jdmrenovations
Definitely an engineer...he will do actual calcs...
Definitely an engineer...he will do actual calcs on it...some contractors will use their intuition instead of data...not always good.
DIY Home Repair Forum:
HVAC
01-17-2012, 10:17 AM
Replies:
12
Heat Retention Issues
Views:
8,708
Posted By
Jdmrenovations
Knowing replacement window contractors in this...
Knowing replacement window contractors in this area like I do...I doubt they did anything at all. Most of them cut the old out behind the casing, slide in the new, cover the exterior damage with...
DIY Home Repair Forum:
Framing and Foundation
01-16-2012, 02:43 AM
Replies:
19
Central basement support beam
Views:
5,180
Posted By
Jdmrenovations
I'm guessing they went up one stick at a...
I'm guessing they went up one stick at a time...thinking about doing it solo makes my back hurt, so I'm not gonna :D
DIY Home Repair Forum:
Carpentry and Woodworking
01-16-2012, 02:37 AM
Replies:
4
Cutting header
Views:
424
Posted By
Jdmrenovations
2x4 header doesn't sound right...usually 2x6 at...
2x4 header doesn't sound right...usually 2x6 at minimum.
Gable wall in this garage, maybe? People will often set small headers in gable walls when they aren't even needed...just to make it look...
DIY Home Repair Forum:
Framing and Foundation
01-16-2012, 02:31 AM
Replies:
1
Sagging floor
Views:
611
Posted By
Jdmrenovations
Well, if you get under there and see alot of rot,...
Well, if you get under there and see alot of rot, all this info I'm about to type will be irrelevant...I'm assuming that the joists are in decent shape, just sagging from the weight of time. I'm...
DIY Home Repair Forum:
Walls and Ceilings
01-16-2012, 02:09 AM
Replies:
5
Question about removing some walls
Views:
513
Posted By
Jdmrenovations
A few of the first checks are relatively simple...
A few of the first checks are relatively simple for anyone to do...usually.
Find the floor joist direction, bearing walls are perpendicular to them both top and bottom.....usually.
Bearing...
DIY Home Repair Forum:
Roofing and Siding
01-13-2012, 04:08 PM
Replies:
11
How to inspect/approve new roof?
Views:
1,135
Posted By
Jdmrenovations
Third generation company who hired a sub to do...
Third generation company who hired a sub to do the work...
IMHO, customer service lapses like that are done by people that look at their job as just a job...put their 8 hrs in and cash a check. ...
DIY Home Repair Forum:
General Chit-Chat
01-13-2012, 03:59 PM
Replies:
80
Whats The Price of Unleaded Gas Where You Are?
Views:
2,216
Posted By
Jdmrenovations
$3.49 in MD...don't even think of goin down to...
$3.49 in MD...don't even think of goin down to DC...$4.25 to $4.50 for regular unleaded. Good news is, our Gov doesn't think the state gas tax is high enough...he wants to raise it 15 cents per...
DIY Home Repair Forum:
General Home Improvement Discussion
01-13-2012, 03:52 PM
Replies:
8
Tiling a backsplash
Views:
1,321
Posted By
Jdmrenovations
I'm skeptical...looks good now, what about 3 yrs...
I'm skeptical...looks good now, what about 3 yrs from now?
My guess would be cracked grout on tile sheets that aren't sticking like they used to.
DIY Home Repair Forum:
Walls and Ceilings
01-13-2012, 03:38 PM
Replies:
7
Corner Molding question
Views:
1,010
Posted By
Jdmrenovations
Normally what we do, too. You can use an "L"...
Normally what we do, too. You can use an "L" channel after the fact, but it can be pretty time consuming.
DIY Home Repair Forum:
General Home Improvement Discussion
01-13-2012, 03:30 PM
Replies:
6
tile shower
Views:
937
Posted By
Jdmrenovations
Keep one thing in mind with tile sizing...larger...
Keep one thing in mind with tile sizing...larger tiles can be much harder to get correct slopes and a good look in a shower pan (unless it's a large area).
Showing results 1 to 25 of 54
Page 1 of 3
1
2
3
>
All Sponsors:
IMPERIAL BLADES
DumpsterSpot.com
Newest Threads
Your house is how old?
Paint Chiping in Bathtub
Driveway Sealer
drylocking basement and removing mold on concrete
Bathroom tiling
Flooding Driveway
One Word Game
Completed Sanding, two questions before applying urethane finish.
Install Quarter Round when there is large gap underneath the baseboard?
Sistering floor joists in my hunting cabin to stop floor movement
Shower pan
Need opinions on what to do here... (Pics Included)
Possible mold problems??
Need some help
Looking for new HVAC and move furnace?
Exhaust Fan In Bathroom
FOLLOW US ON