DIY Home Improvement, Remodeling & Repair Forum > Search Forums > Search Results




Showing results 1 to 5 of 5
Search took 0.01 seconds.
Search: Posts Made By: pbv
DIY Home Repair Forum: Windows and Doors 12-07-2012, 07:16 PM
Replies: 10
Views: 1,387
Posted By pbv
OK, Here goes: I have edited the...

OK,

Here goes:

I have edited the original CAD to include the "dressing up on the outside as well as the 3/4 inch hinge jamb and sandwiched the 2x4 box frame between the plywood layers.
...
DIY Home Repair Forum: Windows and Doors 12-07-2012, 06:04 PM
Replies: 10
Views: 1,387
Posted By pbv
So it would be better then, to use a wood plank. ...

So it would be better then, to use a wood plank. 4.5 inches wide x 3/4 inches thick to act as the jamb. I would flush mount this to the exterior wall and then shim it plumb vertically to ensure the...
DIY Home Repair Forum: Windows and Doors 12-06-2012, 09:04 PM
Replies: 10
Views: 1,387
Posted By pbv
Sorry for the delay, work has been busy. I have...

Sorry for the delay, work has been busy. I have not built the door in any way yet. Only the rough opening for the door is there. It only exists as a CAD drawing.

You think it would be better to...
DIY Home Repair Forum: Windows and Doors 12-03-2012, 09:11 PM
Replies: 10
Views: 1,387
Posted By pbv
The door in my cad is 4.5 inches thick. I was...

The door in my cad is 4.5 inches thick. I was going to use 4 inch wide wood panels over the face to cover the gap on the left (non-hinge) side.

I expect the door to weigh approx 200-250lbs when...
DIY Home Repair Forum: Windows and Doors 12-02-2012, 08:29 PM
Replies: 10
Views: 1,387
Posted By pbv
Door project

Hello,

This is my first post so I am sorry if anything comes across as confusing. I am planning on replacing the door a utility room in my house. Currently we use it to store bedding, cleaning...
Showing results 1 to 5 of 5