Crumbling/cracking problem with new driveway

House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Myrlok

New Member
Joined
Feb 23, 2012
Messages
4
Reaction score
0
Last July, I had a local company install a new concrete driveway for me. At first I was satisfied with their work, but over the last few weeks some problems have arisen. While I was shoveling snow a while ago, I noticed that not only has the driveway already cracked all the way across, but that the surface of the cement had started to form what looked like blisters across a wide area. I noticed that if I stepped hard on the cement in that area, it make a weird crunching noise.

I kept an eye on it for a week or two, and things have really gotten worse quickly. The blisters turned into pits, and now the surface of the cement over an area of about a foot square has shattered into smaller pieces, and the blistering/pitting that I first noticed seems to be spreading. Needless to say, I'm pretty unhappy.

The company told me that the driveway was guaranteed for a year, but I don't have that in writing (I know, stupid mistake...lesson learned). I called the company owner and told him what was going on. He says that it sounds like spalling caused by the salt that people put on sidewalks and roads for de-icing. We have never used salt on the driveway, and the affected area is on a part of the driveway that the car wouldn't usually be sitting on anyway (farther from the garage than we usually park it). It seems that he's basically trying to blame the problem on me for not sealing the driveway, which I didn't know was necessary. According to my reading on the Web, properly mixed and poured cement should last for years and be able to handle road salt.

I guess my question is, is the company owner right? Is this all my fault for not applying a sealer, or can I reasonably hold them to their guarantee and ask them to redo the work?
 
Posting a few pictures would provide a better path to reasonably accurate advice. And without a written warranty of any kind, your chances of getting the contractor to make things right are at best, quite slim.

The crack you mentioned could be caused by inadequate control joints (number and depth), or joints that weren't installed in time while initial set was taking place. Cracks related to the latter usually show up close to one or more existing joints.

The other problem, localized failures, is often the result of soft aggregates (most common is chert) located just beneath the surface. They absorb water, increase in size especially when frozen, which causes the concrete above them to "pop out," usually leaving a single, large piece of fractured, white-colored aggregate at the bottom of the opening. If the crumbling is strictly confined to just the one area you mentioned (the defect is known as scaling), it's more likely caused by over-working that area during finishing operations, or adding too much water during finishing. And if the deterioration eventually shows up over larger areas, it could be the result of failure to specify an air entrainment admixture in the mix. Failure to utilize proper curing techniques on the fresh concrete can also result in eventual performance problems, although the most common symptoms of that would be closely-spaced, shallow map-type cracks.

Concrete flatwork placed with reasonable care stands a better chance of resisting freeze-thaw cycles if it is sealed before freezing temperatures are experienced. Your failure to do so may have contributed to the deterioration rate of your driveway, but there are other things going on that are the root cause of the problem(s). I've personally poured dozens of driveways and patios, and often didn't apply any sealers of any kind. And I'm aware of only one that developed a scaling problem, caused by over-working (with added water) an area that had developed a flash-set while finishing.

The best way for an accurate assessment of what you have is to request an analysis by a concrete testing lab. They will take some samples, and perform a spectroscopic examination of same. The usual charge of several hundred dollars (for minimal sample analysis) varies by location, but the specific results you would be given will be worth it should you need verification of what was done incorrectly, to validate your request for a new driveway from the contractor. A Small Claims Court claim might be your best means of resolution.
 
Last edited:
Here are a few pictures of the worst area. It's about one foot by two feet long. It's really affected a much larger area, though. If you press down with your fingers on the cement all around the spot, it gives as if there's air between the surface layer and the lower layer of concrete. I just have a hard time believing that even if a little salt got on the driveway and caused damage, that it could be this extensive after just a few months.

I got in touch with the contractor and, while he sounded pretty grouchy about it, he's going to come by sometime in the next few days to look at it. I'm hoping that we can reach some kind of agreement without having to resort to small claims court.

test 008.jpg

test 010.jpg

test 011.jpg
 
Bridgeman: just a couple questions to clarify.
Do they use the same salt on brides that might have found it's way onto this driveway?
Would you expect to see this kind of dammage caused by salt and over what period of time?
 
Holy crap! That is definitely not the result of salt and/or not applying a sealant.
Looks like a paper thin layer of concrete smoothed out over rough aggregate.
From what I'm seeing in the first pic, you can expect this hole to grow 10x in size.
I would settle for nothing less than having the entire driveway torn up and repoured.
 
That is not a salt problem or even the calcium cloride they are using now. That looks like a mix issue. If I was the contractor, I would not be happy with my supplier....unless it was July, and the ground took all my water.:D

I agree with KOK, this driveway looks like a do-over.:(
 
I see some very big placement and finishing problems. If it a mix from a ready-mix concrete plant the volume is a load is so large and spread out, there would more of a general problem over a large area and fairly uniform. If the contractor made the mistake of mixing on site, that could account for the apparent differences in the concrete is some areas, but more can be expected to show up over time.

I also suspect the concrete used was not air-entrained to increase durability in area prone to freezing.

Dick
 
What the pix show is not salt damage, nor is it damage resulting from just overworking the finish with a minimal amount of "baptizing" water. That type of failure is always much shallower, and often doesn't loosen any large rock in the mix.

There appears to be a complete matrix failure of significant depth, and the causes of same can best be determined by lab analysis of core samples. It would be worthwhile to sweep off all of the loose material, then tap soundly with a hammer on what's exposed underneath to see how badly the deterioration is and how far it goes down. I suspect the concrete underneath will be soft and pulpy. Before the contractor shows up, it would also be a good idea to sound the adjacent (undamaged) areas with a chain-drag, which will show where more deterioration will soon be visible by the differences in sound. Delaminated areas will sound dull and hollow, instead of having a higher-pitched, almost ringing sound.

Could have been caused by a gasoline spill if they used a power trowel and refueled it while standing out on the slab (I've seen it done!), or even something as simple as adding a concentrated set-retardant admixture directly into the agitating mixer on-site, instead of adding it with water at faster mixing revolutions.

Hopefully, the supplier and contractor will see the problem as being their responsibility to make right.
 
Well, after about a month of playing phone tag and getting ignored, I got fed up and filed complaints against the company with BBB and AngiesList. I got his response to the BBB complaint today - he's sticking to the magnesium chloride excuse and will not admit any fault, and is refusing to replace or repair the concrete or refund any money.

He described the problem as "a few small areas of surface decomposition" and claimed that he had come to the house and inspected it. If he did, I sure never saw him, and I'm home most of the time.

I comforted myself a bit by posting my photos to the Angie's List review. No response from the Angie's List people yet. I am feeling pretty helpless and angry and don't really know what to do next. If I could prove through some kind of independent analysis that the concrete failed and salt wasn't the problem it might help, but I don't know how to find a company that does that kind of thing for residential properties and probably couldn't afford it anyway.
 
Well, after about a month of playing phone tag and getting ignored, I got fed up and filed complaints against the company with BBB and AngiesList. I got his response to the BBB complaint today - he's sticking to the magnesium chloride excuse and will not admit any fault, and is refusing to replace or repair the concrete or refund any money.

He described the problem as "a few small areas of surface decomposition" and claimed that he had come to the house and inspected it. If he did, I sure never saw him, and I'm home most of the time.

I comforted myself a bit by posting my photos to the Angie's List review. No response from the Angie's List people yet. I am feeling pretty helpless and angry and don't really know what to do next. If I could prove through some kind of independent analysis that the concrete failed and salt wasn't the problem it might help, but I don't know how to find a company that does that kind of thing for residential properties and probably couldn't afford it anyway.
Is this co. a license contractor. , then call the inspector at your building agency. If he got a permit or didn't get a permit If he did not do it right then its the inspector job to go after him. He will have to make it right or lose his license.
If you had some one do the job that is not licensed or insured, then that was poor judgment on your part. Paul
 
As far as I can tell from my city's building department website, this type of project doesn't require a permit, so I don't know if the inspector would be interested. The company is licensed and insured, unless their website is lying.
 
As far as I can tell from my city's building department website, this type of project doesn't require a permit, so I don't know if the inspector would be interested. The company is licensed and insured, unless their website is lying.

When a customer puts in a complaint it doesn't make any difference if the inspector is interested or not its his job. Paul
 
It's not his job to inspect something that dos not require a permit or an inspection. I have not heard of a drive ever requiring an inspection.

That is not damage from salt. That is complete concrete failure. Have you tried contacting the actual concrete supplier?They might send someone out to have a look.
 
Wow with a picture like that, you should go straight to lawsuit.

I do not know where you live, but in my state, I was able to file a lawsuit under $10000.00 pro-se (without lawyer) and won $8000.00 from a former client who owed me money.

It cost me about $300 in various filings and fees, but the value of seeing the deadbeat client show up in court over the threat of arrest was pretty sweet.

Collect your paperwork, take pictures, get an 'expert' who can attest that this is shoddy work (a couple of other licensed contractors will do) and make yourself a lawsuit.

It is not for everyone. I am a very smart guy, and it can be a very confusing process, but it can work.
 
I would file a complaint with your states contractor licensing board. It would be worth a call to see if they can champion your cause. Or try your local TV station, they love human interest stories like this.
 
I'll repeat my earlier suggestion, and say that you need to file a complaint in your local Small Claims Court--sooner the better. In addition to the photos you already have, you will need written quotes from licensed contractors, covering both the removal of the junk concrete and its complete replacement. Your case will carry much more weight if the contractor did not give you specific written instructions for sealing the concrete; you need to make that a point in your Court argument.

I'm still a licensed P.E. in Colorado, and have performed literally thousands of inspections of concrete structures in dozens of states in the last 40+ years. In my professional opinion, your concrete failure is not a result of not sealing the surface. PM me if you want additional information and suggestions.
 
I would get expert testimony on how long concrete should withstand the elements in your area and exactly what went wrong with this company's work and take him to small claims court, based the price you paid for this company's work. Small claims is very easy and not hard to file and he just might change his tune once he gets a summons that he is being sued.
 
Back
Top