DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Flooring > Patriot Dblwide: tile backsplash over orig kitchen wall?

Help Support House Repair Talk by donating using the link above.
Thread Tools Search this Thread
Old 10-15-2008, 06:23 AM  
Junior Member
Join Date: Oct 2008
Posts: 1
Default Patriot Dblwide: tile backsplash over orig kitchen wall?

Hi, The questions will pertain to a Patriot Doublewide home.
We spent 2 weeks pulling out the original walls in the house before we moved in and put in sheet rock. However in kitchen we did not, and now I want to tile a backsplash. I was wondering, can I tile over that kind of material? I know it does not hold wallpaper very well, as my bathroom attests to that.
Also, how can you tell if a wall in a dblewide is load bearing. I have a center wall that separates the kitchen and living room, with stairs leading to basement right in the middle. I want to take the bottom of the wall , up about 7 ft out. Keep the top 2 feet or so. I could open up the staircase, so it doesnt look like stairs down to the dungeon. Maybe put some wood spindles . Than ks

erinsbee is offline  
Reply With Quote
Old 10-15-2008, 07:31 AM  
Square Eye
Senior Member
Square Eye's Avatar
Join Date: Jan 2006
Posts: 1,273
Liked 9 Times on 6 Posts


The original walls in a doublewide are made to flex with the home. That's why you can't buy a new one with conventional drywall. The trim strips at the joints allow the movement needed. Unfortunately, this also means that a hard, rigid surface like tile usually won't work.

As far as removing or modifying walls? Well, by replacing what you had on the walls with heavier drywall, you may have already compromised the integrity of the home. These homes are not built to handle the loads of 1/2" or 5/8" drywall.

The same rule applies here when looking at walls in any other home, Assume all exterior walls are load bearing, assume all walls that run parallel to the ridge are load bearing and then get an engineer, a factory rep or a qualified contractor to look at your home and determine which walls are load bearing. Someone with a license and liability insurance.

I certainly understand why you didn't want to drywall your kitchen, The cabinets installed in these homes are near impossible to re-install after changing the wallboard. The cabinets are made as soon as the factory wallboard goes up and they're made to fit where they are. Often there are no backs in the cabinets and when you open the doors, you can see the wall. Anyway, when you take them down, sometimes they come down in pieces.

I wish I could be more helpful but without actually being there, there's no way Anyone can say which walls are load bearing.
Square Eye is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Kitchen backsplash/drywall replacement depawl Walls and Ceilings 3 10-03-2012 09:43 PM
Kitchen Backsplash Help! ndo6532 General Home Improvement Discussion 3 01-27-2012 06:19 PM
Tile Backsplash behind Laminate Countertop??? HalCrimm Decorating and Design 7 06-21-2011 07:37 AM
New to tiling...doing a glass mosaic tile backsplash Quattro Walls and Ceilings 5 03-24-2010 08:03 AM
Tile backsplash in kitchen karenrpcv General Home Improvement Discussion 4 05-25-2007 08:45 AM

Newest Threads