Exterior door stile splitting.

House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Rwh56

Member
Joined
Aug 23, 2011
Messages
20
Reaction score
2
I am trying to rejuvenate a wood panel exterior door. It's a side door that opens at ground level with a four inch high threshold. So, it gets a lot of exposure to rain and snow. I removed the door and trimmed the bottom edge with a router to clean it up for painting. I noticed the bottom endgrain of the hinge side stile has many splits. One split visible on the face of the stile is about three inches long. The stile is thick enough that I cannot widen the splits to pour in some wood glue or epoxy.

I would like to glue up the splits to stop the splits from growing. And, I would like to seal up the endgrain to prevent the door from absorbing more moisture.

Thanks in advance for any advice.

Rob
 
If you can source the same wood you could repair the crack by making a shallow saw cut to take out both sides of the crack and cut a peice to fit and fill the cut line and glue it in.
 
Hi there,
You could try pulling the door together with a pipe clamp.
When you have it tightened up as far as it will go put some long screws
in from the edge of the door to connect the stile to the bottom rail.
You can usually find up to about 5" screws in the specialty screw department
at the hardware store.

Drill about a 3/8" hole in from the edge about 1/2 way through the stile. Then
run the screws all the way in so that they have about half or more of their
length into the bottom rail of door. If the door is a hardwood you will probably
have to drill a pilot hole for the threaded part of the screw.

You can plug and sand the holes in edge of door or fill them with wood filler.
I like Bondo for paint grade work but don't let it get away from you as it hardens!

Regarding sealing; I use a waterproof glue to seal the bottoms of my exterior
doors. I usually thin it down a little so that it brushes on easily. Put an extra
coat on the end grain area for added protection.

If you have a door shoe on the bottom of your door; you can seal across
the top of it with a polyurethane caulk. Put a piece of blue tape on the door
just above the shoe and at the top of the door shoe. Apply bead of caulk
and press in and wipe off the excess with your finger. Pull off the two pieces
of tape at the same time while caulk is still wet. Messy little job but effective
in keeping water from slipping in behind the door shoe.

I hope that helps!
RC/DG
 
Back
Top