venting through sill

shop deals on amazon
SpartanEpoxies
Shop deals on ebay
Advertise with us
House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
E

ejbaron

New Member
Joined
May 18, 2009
Messages
1
Reaction score
0
The basement of my Chicago frame house (built 1895) was finished 20 years ago. They put a ceiling fan in the bathroom down there but didn't vent it. The fan is three feet from an exterior wall. The wall is six feet of limestone foundation topped with what appears to be a 4" wide x 9" tall sill. The sill has notches that the joists rest in. The fan sits in the ceiling between two of those joists. This means any duct work would have to go straight through that sill.

Is it a bad idea to drill through the sill to vent the fan?

I was surprised to find no mildew/mold/rot in the joists despite all the moisture that's been pushed up there over the years.

The hope is, properly venting the fan will keep the basement dryer. Just not sure it's worth messing with that sill.

Maybe there's a better way to vent a basement fan?
 
ejbaron said:
The basement of my Chicago frame house (built 1895) was finished 20 years ago. They put a ceiling fan in the bathroom down there but didn't vent it. The fan is three feet from an exterior wall. The wall is six feet of limestone foundation topped with what appears to be a 4" wide x 9" tall sill. The sill has notches that the joists rest in. The fan sits in the ceiling between two of those joists. This means any duct work would have to go straight through that sill.

Is it a bad idea to drill through the sill to vent the fan?

I was surprised to find no mildew/mold/rot in the joists despite all the moisture that's been pushed up there over the years.

The hope is, properly venting the fan will keep the basement dryer. Just not sure it's worth messing with that sill.

Maybe there's a better way to vent a basement fan?
Click to expand...

Be careful! The warm air from the basement will cause significant condensation when it hits our lovely -20º January days. There's probably a reason it wasn't vented. A can of air-freshener is a much cheaper option.
 
Much better to have condensation outside than between joists. Main reason to vent a bathroom is to get the moister outside, not odors, though that is a consideration. And better to have them outside too.
Can you run ducting, flexible dusting OK here, above sill thru rim joist or band? Or run between joists to place you can go outside? Maximum size hole thru 2X"X" joist is 1/3 width of joist, no closer than 2" from top and bottom. 3" hole thru your 4X10 would be safe, not so easy to cut. A larger hole 4" could be cut thru sill since it is supported along whole lenghth, a section could even be cut out as long as it is not under a joist or stud, and sill attached to foundation, plate attached to sill, within few inches both sides of gap. Attachment can be toenailed or wood, or better, metal "mending plate", sill and plate not going to lift, you just don't want them moving laterally
Flexible duct available in 3 and 4" diameters at HD. Rectangular ducts at HVAC supply.

Position outlet so "cheesy" condensation does not freeze on walks or drives. -20? Yall are nuts.Move to sunny southland where +40 is blood chilling and mild balmy summer days are 100+
 
Last edited:
You must log in or register to reply here.

Latest posts

Back
Top