Streamin1972
Member
- Joined
- Nov 24, 2006
- Messages
- 15
- Reaction score
- 0
I just installed my new bathroom vessel sink. All connections are good and dry... with the exception of where the tail piece screws in to the strainer body. The manufacturer recommends pipe joint sealant and shows the teflon type tape. I have used that, and because the threads are so fine, it pushes it's way out when screwing in the tail piece... thereby allowing it to leak. Is there a liquid or brush on type pipe joint sealant?
Thanks in advance. This one little glitch has been quite annoying, and is holding up my progress!
Barry
Thanks in advance. This one little glitch has been quite annoying, and is holding up my progress!
Barry