Cutting luan board

SpartanEpoxies
shop deals on amazon
Advertise with us
House Repair Talk

Help Support House Repair Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
T

tractng

Well-Known Member
Joined
Jul 2, 2007
Messages
201
Reaction score
9
Guys,

Trying to cut a bad piece of a luan board with laminiating fiberglass sheet (cutting horizontal about 7ft wide). Right now that piece is part of my front wall of my travel trailer. Below the sheet is a metal frame that has a slight curve (gap).

Any recoomended tools to use to cut the sheet?

Thickness of the board is 1/8".

tntrac
 
I doubt a circuler saw is the way to go, reason being is when cutting the material it needs to be cut from the back side so any chips do not show, also trying to cut around a curve with one will be a challange.
An ossilating saw may be a better choise.
Mark your line and cut along the line with a utility knife to keep it from chipping as bad.
 
Last edited:
You must log in or register to reply here.

Latest posts

Back
Top