DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Plumbing Forum > Bath Tub Replacing




Reply
 
Thread Tools Search this Thread Display Modes
Old 03-06-2011, 12:49 PM  
oldognewtrick
Lost And Found Dept
HRT_ADMIN.png
 
oldognewtrick's Avatar
Join Date: Jul 2009
Location: Nashville, TN
Posts: 7,420
Liked 748 Times on 613 Posts
Likes Given: 235

Default Bath Tub Replacing

I own a condo that my daughter and son-in-law live in that was built in the 70's. The tub is starting to get scratched and pretty nasty looking from years of use. I was thinking of replacing it but how much trouble will I have getting a new tub in there without taking a wall down? With all the horror stories about some of the coating or covering companies is replacement my best option? It is a cast iron/porcelain unit.


oldognewtrick is offline  
 
Reply With Quote
Old 03-06-2011, 02:42 PM  
DUNBAR
Master Plumber
 
DUNBAR's Avatar
Join Date: Jun 2009
Location: Northern Kentucky/Greater Cincinnati Area, Kentucky
Posts: 23
Default

If you're wanting to put a new cast iron tub in, removal is difficult.

An old padded blanket, sledgehammer will break up the old one into pieces, send it to the scrap yard for $$. I wouldn't suggest removing it as one piece.... too much a risk of a back injury.


Getting the new one in is a duty, will require a few helping hands. Spend good money on the product so you get longevity of finish on the tub.


I have seen reliable coatings installed on tubs, ones that have went many years and looked better than the original coating.


DUNBAR is offline  
 
Reply With Quote
Old 03-06-2011, 10:35 PM  
nealtw
Contractor
Join Date: Nov 2010
Location: Upper Fraser Valley, British Columbia
Posts: 14,215
Liked 1453 Times on 1281 Posts
Likes Given: 2500

Default

What kind of tub is it?
nealtw is online now  
 
Reply With Quote
Old 03-07-2011, 06:39 AM  
oldognewtrick
Lost And Found Dept
HRT_ADMIN.png
 
oldognewtrick's Avatar
Join Date: Jul 2009
Location: Nashville, TN
Posts: 7,420
Liked 748 Times on 613 Posts
Likes Given: 235

Default

Quote:
Originally Posted by nealtw View Post
What kind of tub is it?
Cast iron.
oldognewtrick is offline  
 
Reply With Quote
Old 03-07-2011, 06:40 AM  
oldognewtrick
Lost And Found Dept
HRT_ADMIN.png
 
oldognewtrick's Avatar
Join Date: Jul 2009
Location: Nashville, TN
Posts: 7,420
Liked 748 Times on 613 Posts
Likes Given: 235

Default

Quote:
Originally Posted by DUNBAR View Post
I have seen reliable coatings installed on tubs, ones that have went many years and looked better than the original coating.
Anything in particular I should look for?
oldognewtrick is offline  
 
Reply With Quote
Old 03-07-2011, 01:03 PM  
DUNBAR
Master Plumber
 
DUNBAR's Avatar
Join Date: Jun 2009
Location: Northern Kentucky/Greater Cincinnati Area, Kentucky
Posts: 23
Default

Quote:
Originally Posted by oldog/newtrick View Post
Anything in particular I should look for?


Definitely stay away from the 'answer in a can' product at home depot. That is around $40 and it's rental property grade product. You cannot expect much from that design.


The 'majority' of applications I've seen using this product have been for more established property owners, in which only 1 or 2 people are using the tub on a daily basis.

Every once in awhile I see it done on a house where multiple people live, meaning upwards of 4-5 people with kids.


There are numerous companies probably in your area that do this type of work. I would recommend anyone that has over 10 years in the business in one location, a clean BBB record that would lead one to believe that the reliability of the product is holding out.


One crucial mistake made in this application:


Those who put these new finishes on MUST remove the chrome trim for the overflow opening along with the tub drain chrome opening.

That is 2 areas where porcelain always comes off/rust shows up and can create a bad situation down the road when the trim is replaced and that area is slowly going beyond what the trim covers.

If the first statement that comes out of their mouth is "we are not plumbers" then tell them they cannot do their job correctly with leaving those two items intact. That's not how the tub was first glazed and they know it.

They should have a plumber that's available to do the task so your investment lasts.
DUNBAR is offline  
 
Reply With Quote
Old 03-07-2011, 04:45 PM  
oldognewtrick
Lost And Found Dept
HRT_ADMIN.png
 
oldognewtrick's Avatar
Join Date: Jul 2009
Location: Nashville, TN
Posts: 7,420
Liked 748 Times on 613 Posts
Likes Given: 235

Default

I think I will do a little reasearch before I take the 5lb hammer to the tub and make a bigger mess. Thanks for the replys.

Dunbar, where are you located at in N.Ky. I lived for a couple years off Buttermilk Pike in Lakeside Village. Can't figurse out for the life of me why I moved away. You know any of the folks at Geiler Plumbing? I had a really good friend who use to work there.
oldognewtrick is offline  
 
Reply With Quote
Old 03-07-2011, 07:33 PM  
nealtw
Contractor
Join Date: Nov 2010
Location: Upper Fraser Valley, British Columbia
Posts: 14,215
Liked 1453 Times on 1281 Posts
Likes Given: 2500

Default

A good refinnish will last about ten years and they work really good if your selling the unit.
nealtw is online now  
 
Reply With Quote
Old 03-08-2011, 01:03 AM  
DUNBAR
Master Plumber
 
DUNBAR's Avatar
Join Date: Jun 2009
Location: Northern Kentucky/Greater Cincinnati Area, Kentucky
Posts: 23
Default

Quote:
Originally Posted by oldog/newtrick View Post
I think I will do a little reasearch before I take the 5lb hammer to the tub and make a bigger mess. Thanks for the replys.

Dunbar, where are you located at in N.Ky. I lived for a couple years off Buttermilk Pike in Lakeside Village. Can't figurse out for the life of me why I moved away. You know any of the folks at Geiler Plumbing? I had a really good friend who use to work there.


I'm in Independence Kentucky. I'm actually working off of Buttermilk Pike thursday.

I worked in new construction for Geiler for a brief time, then tried to get into their commercial service division with no luck.

That was over 12 years ago, decided I'm better off doing for myself. I'm not complaining.


You probably moved away because of the brutal winters here. This past one was almost disrespectful.


__________________
[URL="http://DunbarPlumbing.com/"][SIZE="1"][B]Northern Kentucky Plumbers[/B][/SIZE][/URL] [SIZE="1"][B][URL="http://YouTube.com/DunbarPlumbing/"][COLOR="Red"]Plumbing Videos![/COLOR][/URL][/B][/SIZE]
DUNBAR is offline  
 
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Master Bath or Separate Bath? kmb383 General Home Improvement Discussion 8 11-01-2010 11:11 AM
Need new bath - please help cubiculum Plumbing Forum 1 11-29-2009 09:06 AM
Replacing bath/light/fan need wiring help bggb29 Electrical and Wiring 1 08-15-2009 07:03 PM
Replacing the entire base of a roof versus replacing parts of the roof jigsawsaver Roofing and Siding 3 07-04-2009 06:04 AM
Bath? Leal General Home Improvement Discussion 1 09-14-2008 09:44 PM

Newest Threads

LATEST SPONSOR DEALS