DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Bricks, Masonry and Concrete > Advice on Concrete pool coping needed.




Reply
 
Thread Tools Search this Thread Display Modes
Old 05-22-2012, 05:16 PM  
DJK555
Junior Member
 
Join Date: May 2012
Posts: 2
Default Advice on Concrete pool coping needed.

I just opened a 16X32 in ground Vinyl liner pool that has a concrete coping backed up with concrete pavers forming a deck. The coping was made from coloured concrete and was painted in the past. Last year I did some spot repairs on the coping and repainted the whole thing to match colours. This year, when removing the water bags and winter cover there was a number of areas where the coping had spalled and the new paint had flaked. The flaking paint I can deal with but I am concerned about the spalling/flaking concrete. Any suggestion on how to address this problem will be appreciated.



__________________
DJK555 is offline  
 
Reply With Quote Quick reply to this message
Old 05-23-2012, 07:51 PM  
BridgeMan
Senior Member
 
BridgeMan's Avatar
 
Join Date: Aug 2011
Location: Cottage Grove, Oregon
Posts: 738
Liked 75 Times on 67 Posts

Default

The concrete deterioration you're seeing is actually called scaling, not spalling. If the concrete coping is older, but hasn't shown any scaling until after you painted it, I suspect the paint could have possibly triggered the scaling mechanism in the concrete. Not very common, but a definite possibility.

If the concrete coping is reasonably new (less than a year or two), then the chances are good that the scaling was going to happen whether or not the concrete was painted. Scaling is usually caused by over-working the concrete during finishing operations, making the water-cement ratio too high at the surface. Sometimes it can take a year or more to show up.

There are no easy fixes. It will take a lot of work to remove all of the bad (and potentially-bad) stuff before a good coating can be applied. Sand-blasting or hydrodemolition are several removal methods that work well.



__________________
BridgeMan is offline  
 
Reply With Quote Quick reply to this message
Old 05-24-2012, 10:29 AM  
DJK555
Junior Member
 
Join Date: May 2012
Posts: 2
Default

Thanks Bridgeman.

What is your opinion of the epoxy based concrete resuracing products like Armor Poxy for this type of application? http://www.armorpoxy.com/

__________________
DJK555 is offline  
 
Reply With Quote Quick reply to this message
Old 05-28-2012, 09:35 PM  
BridgeMan
Senior Member
 
BridgeMan's Avatar
 
Join Date: Aug 2011
Location: Cottage Grove, Oregon
Posts: 738
Liked 75 Times on 67 Posts

Default

I have no experience with Armorpoxy, or (recent) experience with any epoxy coatings, for that matter. The epoxy coatings I had DOT experience with in the late 1980s, used as "attempted" bridge deck overlays, performed miserably. Several manufacturers' products loosened and came up in large sheets within a few weeks of having been applied, and both applications were done with factory technical reps on hand "to make sure everything was done right."

I suspect a lot of progress has been made in the epoxy surface coating industry in the last 30 year, so you might get lucky. Just make sure your surface prep is up to snuff, getting all loose and potentially loose (delaminated) material removed before you start the application.

__________________
BridgeMan is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Kitchen Countertop Advice Needed kimg30 Decorating and Design 23 07-12-2012 04:07 AM
bad concrete on pool decking mmmon13 Bricks, Masonry and Concrete 14 06-04-2011 08:43 PM
Concrete Driveway Repair - Advice Needed loosescrew Bricks, Masonry and Concrete 9 03-11-2011 10:45 AM
Capacitor advice needed gbharrington General Appliance Discussion 2 09-25-2010 10:33 AM
Furnace Advice Needed gunit HVAC 3 01-10-2009 04:17 PM

Newest Threads

LATEST SPONSOR DEALS