DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Painting Forum > "Wet Edge"




Help Support House Repair Talk by donating using the link above.
Reply
 
Thread Tools Search this Thread
Old 01-23-2013, 03:35 PM  
Curmudgeon10
Member
Join Date: Feb 2011
Location: Manassas, VA
Posts: 47
Liked 3 Times on 3 Posts
Likes Given: 2

Default "Wet Edge"

I'm constantly hearing from TV painters about the need to maintain a "wet edge" when painting a room. But don't you lose that wet edge with a one person crew cutting in? By the time I complete that task, the starting point and more has dried up and there is no more wet edge.

So how important is it, really?


Curmudgeon10 is offline  
 
Reply With Quote
Old 01-23-2013, 06:22 PM  
CallMeVilla
Senior Member
 
CallMeVilla's Avatar
Join Date: Feb 2010
Location: San Diego
Posts: 1,641
Liked 590 Times on 449 Posts
Likes Given: 245

Default

In the corners, yes but it is not as obvious as on the wall elsewhere. I have been using a paint pad for cutting in and it really speeds the work .... unless you prfer a spray rig which ALWAYS has a wet edge.


CallMeVilla is offline  
 
Reply With Quote
Old 01-24-2013, 02:39 PM  
Curmudgeon10
Member
Join Date: Feb 2011
Location: Manassas, VA
Posts: 47
Liked 3 Times on 3 Posts
Likes Given: 2

Default

I like paint pads too, but my technique is not consistent; seems that I will do OK on one or two swipes, but then on the third I'll load too much paint on the thing and it will ooze out on the trim or cabinet...
Curmudgeon10 is offline  
 
Reply With Quote
Old 01-27-2013, 06:21 PM  
RickMerlander
Guest
Posts: n/a
Default

One thing you might try is to run your pad along the edge of the wall section you are going to roll, and then immediately switch to your roller, which will get you in pretty close to the corner, say to within 1/2" - 3/4" of the corner. The brush marks on the 1/2' in the corner usually won't stand out. Then you repeat the process at each edge of the wall.
 
nealtw Likes This 
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Are "latex-modified" and "polymer-modified" thinsets the same? Angelique General Home Improvement Discussion 2 03-13-2014 07:38 PM
edge blocking 5/8" cdx plywood subfloor sansmoto Flooring 6 04-02-2012 08:25 AM
Difference between "baseboards" and "moulding" panzerfaust0 Walls and Ceilings 8 01-18-2012 02:55 AM
"GROUP BUY" price for "SWISSTRAX" Tile Flooring 427HISS Garage & Workshop Forum 3 05-31-2011 01:44 AM
System running Hot while set to "Cool" & "Off" halogen49 HVAC 7 03-06-2011 05:42 PM