DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Walls and Ceilings > sheetrock butts upto cbs question




Reply
 
Thread Tools Search this Thread Display Modes
Old 05-29-2013, 01:55 PM  
beachguy005
Senior Member
 
Join Date: Sep 2012
Posts: 234
Liked 77 Times on 67 Posts

Default sheetrock butts upto cbs question

Hi folks, I'm rocking an interior wall that butts, at a right angle, up to a stuccoed concrete block finished wall.
Normally with rock to rock, I know you would just tape and mud that inside corner but given that it's s/r to stucco is that the best way of finishing the joint?
The new sheetrock will be finished smooth and painted.


Thanks,



__________________
beachguy005 is offline  
 
Reply With Quote Quick reply to this message
Old 05-29-2013, 02:28 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 10,720
Liked 922 Times on 823 Posts
Likes Given: 1590

Default

I don't think there is any rules for this, You may want to add an extra stud to the wall there so you can keep your nails or screws further away from the joint. Finish the joint with a paintable dap caulk, just like you would with molding. To make the filling nicer, you may want to scribe the cut to get a good fit and then trim the face paper on a bit of and angle so you don't have any furry paper sticking out.



__________________
nealtw is online now  
 
Reply With Quote Quick reply to this message
Old 05-29-2013, 03:34 PM  
beachguy005
Senior Member
 
Join Date: Sep 2012
Posts: 234
Liked 77 Times on 67 Posts

Default

Thanks Neal, I do have studs right up tight to the stucco wall. I'm just not sure how long a mud and tape corner joint would hold and if I could get a good blend into the stucco wall's sand finish.
I don't like the cut rock and caulking alone. I may just add a piece of 1/4 round vertically in that corner and be done with it.
Thanks for your reply,

__________________
beachguy005 is offline  
 
Reply With Quote Quick reply to this message
Old 05-29-2013, 04:12 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 10,720
Liked 922 Times on 823 Posts
Likes Given: 1590

Default

A second stud there will allow you to have nails and filler away from the corner, try the caulk, you can always put up a wood trim.

__________________
nealtw is online now  
 
Reply With Quote Quick reply to this message
Old 06-04-2013, 09:18 AM  
Drywallinfo
Senior Member
 
Join Date: May 2013
Posts: 144
Liked 28 Times on 23 Posts
Likes Given: 9

Default

I would use a piece of j-trim on the drywall. Then, caulk if you want, but the j-trim will give you a clean drywall edge. You fasten the trim, setting screws below surface and finish up to the edge of the j-trim with mud, covering the fasteners. See http://t3.gstatic.com/images?q=tbn:A...SVQsinlqfRnXbv for a pic of this trim.



__________________
Drywallinfo is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
sheetrock and plaster question drewdin Walls and Ceilings 10 05-17-2013 11:53 AM
Can I install sheetrock right over existing sheetrock? m2244 General Home Improvement Discussion 5 01-22-2013 03:47 PM
Sheetrock 101 ChuckDiamond Flooring 13 07-24-2009 06:19 PM
Is there a coving that butts with corbels? PhilTheDIY Flooring 5 12-02-2008 02:32 PM
plastering over sheetrock? paguy Walls and Ceilings 0 08-11-2008 11:45 AM

Newest Threads

LATEST SPONSOR DEALS