I recently purchased an inline duct fan for a chilly room in our home and want to wire it to the furnace blower motor directly.
AFter studying the electrical schematic for a while, I thought I had it figured out. I connected the hot and neutral to the very posts on the control board that appeared to match what was feeding the blower but got nothing... it seemed I had completely broken the connection.
Anyone out there have any advice as to where I can connect these and how to connect them?
The schematic scan was too big to upload here so I've included a link to it: HERE
I've highlighted the wires I thought would work - orange goes to "HEAT", white is going to "NEUTRAL". the other 3 are going to "UNUSED MTR LEADS" and the "COOL" switch.
Any advice would be appreciated.