DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > General Home Improvement Discussion > small shower?




Reply
 
Thread Tools Search this Thread Display Modes
Old 05-31-2008, 05:14 AM  
triptakers
Junior Member
Join Date: May 2008
Posts: 12
Default small shower?

Hi!
We're putting a bathroom in our basement as we finish it, and have a TINY bathroom to work with.
Has anyone got (or showered in ) a 32 inch shower stall? Is it a reasonable size (ie can real humans actually use it, or does it feel like the shower on a boat?)

Any ideas for showers in a small space are VERY welcome!
Thanks!


triptakers is offline  
 
Reply With Quote
Old 05-31-2008, 06:40 AM  
inspectorD
Housebroken
HRT_ADMIN.png
 
inspectorD's Avatar
Join Date: Dec 2005
Location: Litchfield, CT
Posts: 4,260
Liked 187 Times on 156 Posts
Likes Given: 464

Default Yup

Shower on a boat ...right on.
Go to your local plumbing supply house...not box store. They will have some set up. I have used the rounded models, more room.


__________________
Just My
Made in the
inspectorD is offline  
 
Reply With Quote
Old 05-31-2008, 08:52 AM  
Daryl in Nanoose
Senior Member
 
Daryl in Nanoose's Avatar
Join Date: Feb 2006
Location: Nanoose Bay, BC
Posts: 764
Liked 4 Times on 4 Posts
Likes Given: 5

Default

I'm with InspectorD on this, round is way better. If you can find one set up then you will be able to stand in it and see if it works for you. I have used 32" ones and yes you can get the job done but I find it's not just the width but the depth to. 32" neoangle is to small, I had a 34" and it worked but if you can find a way to increase that 32" even if it's only 2 inches I suggest you do.
__________________
[url]http://edhome.shawwebspace.ca/[/url]
Daryl in Nanoose is offline  
 
Reply With Quote
Old 06-01-2008, 06:51 AM  
triptakers
Junior Member
Join Date: May 2008
Posts: 12
Default

thanks to you both - since we're not framed yet, we're going to try super-hard to eek out the extra couple of inches - can't change the floorplan too much, though, since we've already been permitted.

The search for the perfect shower continues!

Thanks again!
triptakers is offline  
 
Reply With Quote
Old 06-01-2008, 07:53 AM  
JulieC
Member
Join Date: Jul 2007
Posts: 51
Default

We've got one possibly a bit smaller in our downstairs bath. I call it "the world's smallest shower". The outer width dimension is 31". I'm still getting the hang of "nominal dimensions". It feels very closed in, hard on the elbows. That said, I've showered in there when I was 9 months pregnant. My husband and I have showered in there together ... that was an experience in togetherness :lol. Ours feels dark and confining, a bit more "openness" would be great. The left side has a full-height wall between it and the vanity, I've considered putting a "transom" of glass block above the stall to make it feel more open.
JulieC is offline  
 
Reply With Quote
Old 06-01-2008, 09:26 AM  
manhattan42
Member
Join Date: Mar 2006
Posts: 44
Default

Sterling makes great 4 piece modular shower units that will work nicely for you:

http://www.sterlingplumbing.com/onli...howers_pg.html

I've used their 32" models and at 6'2" and nearly 300lbs have no trouble using them.

Plumbing codes usually limit the size of showers to no less than 30" measured from inisde wall to inside wall.

In most cases you cannot legally install any factory built shower that is less than a standard 32" wide.
manhattan42 is offline  
 
Reply With Quote
Old 06-01-2008, 09:45 AM  
Daryl in Nanoose
Senior Member
 
Daryl in Nanoose's Avatar
Join Date: Feb 2006
Location: Nanoose Bay, BC
Posts: 764
Liked 4 Times on 4 Posts
Likes Given: 5

Default

Quote:
Originally Posted by triptakers View Post
thanks to you both - since we're not framed yet, we're going to try super-hard to eek out the extra couple of inches - can't change the floorplan too much, though, since we've already been permitted.

The search for the perfect shower continues!

Thanks again!
I dought you would have a problem with the inspector, in a lot of cases we call this "on site Alteration.
__________________
[url]http://edhome.shawwebspace.ca/[/url]
Daryl in Nanoose is offline  
 
Reply With Quote
Old 06-01-2008, 02:26 PM  
JulieC
Member
Join Date: Jul 2007
Posts: 51
Default

Quote:
Originally Posted by manhattan42 View Post
Plumbing codes usually limit the size of showers to no less than 30" measured from inisde wall to inside wall.

In most cases you cannot legally install any factory built shower that is less than a standard 32" wide.
That. Our shower is original (I believe) to our 1970's house. I'm not sure it would be allowed today.


JulieC is offline  
 
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Tub faucet leak when shower is on? sbattisti Plumbing Forum 31 09-01-2011 08:59 AM
Can you help a newbie renovate the bathroom shower? cyancat General Home Improvement Discussion 16 05-30-2008 06:47 AM
rebuilding shower floor gregrph General Home Improvement Discussion 7 05-29-2008 10:27 PM
Replace Jacuzzi with shower? mustanger General Home Improvement Discussion 5 01-29-2008 06:20 PM
Noise from Shower Valve nikon876 Plumbing Forum 2 02-28-2007 07:11 PM

Newest Threads

LATEST SPONSOR DEALS