Hello, I am new here and new to " doing it myself " I just moved into a condo with my fiance and I am slowly but surely becoming a spackling expert . I am attempting to install a pendant lamp in my dining room and need some help figuring out the wiring. The wires that are hanging from the ceiling are as follows : Two (2) red wires twisted together and capped, Two (2) black wires twisted together and capped, Two (2) white wires that are not "twisted" together at the ends. There is also the ground wire (bare thick copper wire that is not attached to anything, it is just twirled around at the top. My question is which of these wires do I use when installing the lamp ?
Thanks in advance !!
I did a little browsing and I now know that I have a three way switch, There is a light switch next to the entrance door and a switch next to the kitchen entrance that operate the same light, I hope that helps you to help me.
Last edited by blaksheep67; 08-24-2008 at 12:48 AM.
I did not take it apart. We asked the Superintendent to put in two lamps for us. The box for the first lamp was crooked because it was only secured on one side , there was nothing on the other side (wood beam) to secure it to (I figured it out on my own) I told him I didn't want the lamp hanging off lopsided. The other lamp has steel rods so that you can adjust the height,he didn't install it because I wasn't sure How high or low my fiance would want the lamp to hang over the dining room table. I can attach the ground wires to the new ground screw of the new fixture, I just need to know which wires (black/red) do I attach to the lamps hot wire and if I should twist the two white wires together and attach them to the neutral wire. I also need to know what should I do with the extra wires (just leave them hanging) ? Thanks again.
Speedy - Is it really THAT bad? I do not see cable clamps and I do not see the fancy ground screw, yes. It looks as though someone at least labeled the hot white wire. That is correct in many situations as I understand. Maybe we are not seeing cable clamps in the picture but they are there? Maybe, yea, not likely though.
To the OP - On new fixture - Black to white with tape, white to white, ground to ground. Leave wirenutted connections as is and tuck into box. Assuming all connections in switch and box are correct.
The Handyguys Podcast [url]http://www.handyguyspodcast.com[/url]