DIY Home Improvement, Remodeling & Repair Forum > General Discussion > Introductions > An introduction

Help Support House Repair Talk by donating using the link above.
Thread Tools Search this Thread
Old 09-14-2008, 04:32 PM  
Junior Member
Join Date: Sep 2008
Posts: 1
Default An introduction

Hello all,

Just joined and I am so happy (maybe) to have found this site.
I say maybe because I have a headache from reading up on all my questions and have also discovered I have a lot of research (code) and work to do.

But thats why I DIY I suppose.

I try not to do more than one project at a time, but I have also bitten off more than I should in the past.

I think I know my limitations. But do push the limit some, new things can be a lot of fun, and of course aggravating.

I live in Washington State, I have a pier and beam house (I think), built in the early 60"s, with a (old) plastic covered dirt crawl space which is also vented. The plastic is not sealed etc. I do have a sump pump which = lots of moisture from the amount of rain we get.

I have a whole lot of projects in mind but I am now thinking I should take care of the sealing of my crawl space plastic liner, depending on code.

Believe me, I wish I had found this site a long time ago.

I will probably revisit some of my past projects, perhaps as a lessons learned posting.

Thank you very much for having this forum and the participation.

My home and I appreciate it!!!!

Binictican is offline  
Reply With Quote
Old 09-14-2008, 08:56 PM  
Senior Member
Join Date: Mar 2006
Posts: 2,990
Liked 4 Times on 4 Posts


Welcome Benictican:
If it is possible, you would be better off with a drain laying on top of the footer at the low corner of the house. Then make sure the dirt is sloping away from the house all the way around, even if it takes digging a swale (a shallow ditch that you can run your lawn mower through without trouble) around part of the house.
It is good to have the plastic sealed to the foundation and any piers in the middle, plus the joints should be lapped 6" to 1' and sealed also. Use plastic roof cement to do the sealing porcess.
You could also gain some energy savings by lining the inside of the foundation with 2" thick styrofoam.
glennjanie is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Just an introduction Jclark Introductions 3 10-15-2014 08:15 PM
Re-Introduction kenfields Introductions 5 10-03-2013 11:06 AM
introduction can-am-dan HouseRepairTalk Website Help 0 11-03-2009 07:21 AM

Newest Threads