DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Electrical and Wiring > Add Conduit to a recessed panel

Thread Tools Search this Thread Display Modes
Old 02-16-2009, 12:40 PM  
Junior Member
Join Date: Feb 2009
Posts: 1
Default Add Conduit to a recessed panel


My 200 Amp panel is located in my garage. To add outlets (only one was initially installed on any of the wall surfaces of the garage) for my woodworking hobby, I'd like to add a couple of additional circuits and multiple outlets. I was planning on adding the additional outlets via conduit and surface mounted boxes (all walls and ceiling are drywalled); however, I don't know the best way to run conduit from the recessed circuit panel onto the surface of the wall. Any advice would be greatly appreciated.


BillinSC is offline  
Reply With Quote
Old 02-16-2009, 01:08 PM  
Senior Member
Join Date: Mar 2006
Posts: 409

You should be able to run NMB inside walls. I would mount the first JBOX half in the wall and half out, screwed to a stud. Bring the NMB into the side or bottom of box and install the conduit in the part that sticks out.
CraigFL is offline  
Reply With Quote
Old 02-21-2009, 10:58 PM  
triple D
Senior Member
Join Date: Jan 2008
Posts: 296
Liked 1 Times on 1 Posts

Default new dedicated circuits?

You can cut a small 1" wide channel, from the bottom of the panel downward about 5 or 6 inches. Then knock out a half inch hole in panel bottom. Now you can use a short piece of 1/2" flex to get from panel to first 4 square box. Then you can go surface mount with more flex, or 1/2" pvc from box to box. This will accomidate two or three corcuits easy. Good luck....
[COLOR="DarkGreen"][FONT="Franklin Gothic Medium"]See my work-Check out my album. "Git 'Er Done":D [/FONT][/COLOR]
triple D is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Recessed lighting question RyanBruner Electrical and Wiring 6 11-19-2008 07:21 PM
stove - 50 amp White Red Black Black Conduit - 3 hot? where's green? sholleran Electrical and Wiring 9 01-30-2008 12:58 AM
Service panel connection. Hack Electrical and Wiring 16 01-02-2008 11:34 AM
Main to sub (main lug) panel wiring newdiyer Electrical and Wiring 6 03-30-2007 07:03 PM
Service/breaker panel capacity question... tenderton Electrical and Wiring 1 10-13-2006 05:08 AM

Newest Threads