DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Windows and Doors > Interior door problem




Reply
 
Thread Tools Search this Thread Display Modes
Old 08-03-2009, 03:30 PM  
bsmutz
Junior Member
 
Join Date: Aug 2009
Posts: 4
Default Interior door problem

Hi, all,
I have an interior door issue that I'm seeking help with. I took out an interior door between kitchen and laundry room because the wife wanted a door with windows in it instead of a solid one. The new door is a little heavier than the hollow core door it replaced. Because the old hinge screw holes were getting worn out, I put plywood shims behind the hinge mount locations and am using longer screws.

The problem is that when I open the door to a 90 degree angle from the jamb and sight along the jamb, the gap at the top between door and jamb is greater than the gap at the bottom. When I try to close the door, there is a bigger gap at the top than at the bottom and the top of the door hits the jamb on the latch side. I can lift up on the free edge of the door and shove it towards the hinge jamb, but still can't quite close the door but can take up all of the difference between the door edge and the jamb. I added a third hinge in the middle of the door to help with the extra weight to no avail.

When I use a straight edge/level, the jamb appears level and straight. The door also appears to be level and straight on the face and on the edge (except for about a 1/4" off of level from top to bottom). I can't figure out where this extra gap is coming from. Initially, I thought it was because the door was hitting the door stop in the middle of the jamb, so I moved the top hinge back a little to allow more clearance there. That made the door go past the stop, but the gap is still there as if it were still hitting the stop and pushing the door out at the top. I can't figure out what I'm missing. Any ideas?

Thanks!



__________________
bsmutz is offline  
 
Reply With Quote Quick reply to this message
Old 08-15-2009, 02:57 PM  
glennjanie
Senior Member
 
Join Date: Mar 2006
Posts: 2,990
Liked 2 Times on 2 Posts

Send a message via AIM to glennjanie
Default

Welcome BSmutz:
It looks like you have hung an exterior door in an interior jamb which is too light and not anchored well enough to support the new door.
You may want to consider taking the casing off one side of the door and block and anchor the jamb to the stud more securely. Or you may want to get an exterior door frame and mount it.
Glenn

__________________
glennjanie is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
O'keefe & Merritt Oven Door Problem theokengineer General Appliance Discussion 1 03-26-2012 06:15 PM
interior doors Christian Windows and Doors 8 06-05-2009 12:06 PM
Garage Door Opener problem generic703 Windows and Doors 6 01-14-2009 10:35 PM
Shower door frame problem jgalt Windows and Doors 1 01-02-2009 10:53 PM
Interior door installation teaklumber Windows and Doors 2 02-05-2008 10:30 AM

Newest Threads

LATEST SPONSOR DEALS