DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > HVAC > york HVAC blower not working

Help Support House Repair Talk by donating using the link above.
Thread Tools Search this Thread
Old 07-14-2006, 07:26 PM  
Junior Member
Join Date: Jun 2006
Posts: 6

Hi All,
We could not figure this out.. and had to call the york representative. He figured out the problem in 10 seconds. The problem was that there was an additional inline fuse which we were not aware of that had blown.... because the mice were chewing up the wires from the unit on the outside....
Thanks for all your prompt ideas and repllies!

beaven is offline  
Reply With Quote
Old 01-06-2011, 03:50 PM  
Junior Member
Join Date: Jan 2011
Location: Logan Township, NJ
Posts: 2
Default York HVAC Blower

Your furnas blower plugs into a control module. My blower has three speeds, refer to the schmatic on the panel cover. White wire is the neutral and a black, blue, & red wire for each speed. I took an extention cord and installed spade connectors to allow external power to the fan. This will allow the motor to be tested outside of the panel/furnas controls. This would allow you to verifty the motor will run. There is a capacitor to start the motor which also has spade connectors for easy replacement of the $20 capacitor. I have just completed a repair to my blower motor. The motor would humm when power was applied. The fan could be turned, but the motor would not come up to speed. Turns out the bearing lubrication became a glue and the motor could not spin freely. The GE motor bearings are sealed, no design for additional bearing lube/grease. Since a replacement motor was $200 and was not a direct replacement, I disassembed the motor. I found the bearings are just sleeve bearings. The lubrication had been lost due to being 13 years old and the oil was stored in a fabric/cotton material. I packed the area with grease. But a synthetic motor oil could have been dripped into the fabric to restore lubrication. You can test the fan circuit at the furnas motor spade connectors. Remember, white/neutral is the return for power for all three speeds. So power/voltage can be checked at the spade connectors for each speed. Yorke & Lenox have exclusive rights to the General Electric motor. You may not be able to purchase a exact replacement if you are not an approved contractor. I called six supply houses and checked the internet with no one having a replacement motor available.
Chopsaw2843 is offline  
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
York TM8Y Blower noisy startup akramy HVAC 3 10-31-2016 07:15 AM
New Coleman/York furnace blower erratic Quattro HVAC 8 11-29-2012 09:12 PM
York AC unit not working.. jcherryj HVAC 5 07-08-2012 07:13 AM
York Diamond 80 Blower Problems jimmy_pop HVAC 2 05-06-2010 06:09 PM
York HVAC blower motor replacement TAC HVAC 5 04-13-2010 10:49 AM

Newest Threads