Recent content by joecal

joecaption. Thank you for the response

Kok328, Thank you.

Hello. Need to repaint my fascia which presently has semi-gloss paint on it. I've already scrapped it. I know I should clean the fascia and I've read that I should sand down the paint on it now so the new semi gloss paint will adhere better. I understand that. But what I'd like to know is...

LOL, thanks

I can't do any of that so I'll have to pay someone. I just wanted some input on the cause since I couldn't duplicate the trouble. Thanks

Topphoto Top photo is the drywall about 3 feet directly above the damage on the bedroom floor. Bottom photo is the bedroom floor. Second photo from top is the shiplap which is under the hip roof. I did notice that one of the nails of the shingles on top of the hip roof is protruding a little but...

Hello, you can't see the photos I posted yesterday?

Top photo is the drywall about 3 feet directly above the damage on the bedroom floor. Bottom photo is the bedroom floor. Second photo from top is the shiplap which is under the hip roof. I did notice that one of the nails of the shingles on top of the hip roof is protruding a little but this...

Hello. Recently, my wife moved a bed to clean under it and we discovered that the drywall by the floor trim is bulging out, the trim itself is warped and also bulging, and the adjacent wood flooring is also slightly warped. Also, about 3 feet directly above this damage, there's a line break in...

nealtw. Yes, I already did that and it was hot. Matter of fact the cold water line into the hot water heater has been consistently hot. I don't have one of those thermal expansion tanks.

Well, after doing a little research, I went and bought a water pressure gauge with a lazy hand. I installed it on the outside water spigot to see what the pressure was there. It was 122 which is a lot higher than 80 so I guess I need a need regulator. I'll leave it there for 24 hours to see...

Garmo, Thanks for the reply. Here's the latest: I ended up closing all the single handle faucets except for one which was stuck and the problem continued. And I closed off the clothes washer too. So I figured it was the hot water heater letting water go backwards into the cold water line or...

nealtw, i just took a good look under my kitchen sink and there is a box called an in sinkerator instant hot water dispenser. Now I didn't think it was an issue since I unplugged it when we moved in 8 months ago. I see it has a line from the cold water side but if it's unplugged I don't see...

nealtw, ok I looked on line and I see that that device is installed on the hot water line near where it exits the hot water heater and then there are connecting devices that you put under a sink which connects the hot and cold water. I don't have anything like this on my hot water line out of...