Recent content by johnjh2o

Replace the cad cell

I have installed one for a dental lab. It was used in a sink that they used to cut and shape dental molds.

Sounds like you may have a broken flange.

Washer drains need to be 2". Your sink drain is most likely to be 1.5".

I have seen that done to run up a brick or stone venire.

That sounds like a piggyback setup. Just plug in the plug for the pump, but it will not turn off with out unplugging it.

The traps are installed when the sinks are installed. But they will be S traps because where the waste enters the vent it will be below the trap seal creating a S trap.

By using a long turn DBL TY you have created two full S traps.

Foam will not hold down the flange. It needs to be screwed down to the floor.

Trump should come out with another health care program but also keep Obama care and give people the choice as to which one they want. Then sit back and watch Obama care implode.

What he has below is a cast iron trap. And that is a piece of lead pipe attached to the bushing.

Remove the top one the lower one is a bushing. Can't tell from the picture but that may be lead pipe above the bushing.

The corner brace is what I was looking at. Hard to tell from the picture but if it's flat it's a steel tub but if it's round it's cast iron.

That is not a steel tub it's cast iron. It could weight as much as 180#.

That must have been quite some time ago seeing as I have been in the plumbing business since the late 50's and have always called them open front.:)