Recent content by Quattro

Supplier thinks its the motor. Sending me a replacement. Hopefully I can get it shoehorned in!

Here are some photos! Could the thermostat have anything to do with this? The old furnace would do something similar, but not nearly as often.

How do you test across the contacts while the relay is socketed on the board? How likely is it that a brand new furnace needs a new relay? Edit: I don't see any relays on the board. At least not "conventional" relays... I'll upload pics in the morning.

Thanks for the tip! However, I'm not sure I know where that relay is, or which contacts to measure. I do know how to use my DMM, though!

Hey all, it's been a while, but I'm back with a new question. Thanksgiving morning I installed (with the help of my retired-HVAC-instructor father-in-law) a new gas furnace in my house. Everything went fine, except for an errant screw through the A/C A-coil. Oops, that'll need a recharge! :o...

Is it really "much" cheaper? Materials wise, yes...but the labor of taping, mudding, sanding, priming and painting probably brings it closer. I agree it does look better though. I did not want to give up easy access to the utilities in the ceiling, and with the direct-mount tracks, you only...

Will do. Hope to have it done before winter! :-)

I have a bunch of Ceiling Link waiting to be installed in my basement. Looks good. Just need to finish the walls before putting it up.

If I do that, I'd have to wait until each course has cured before doing another course on top, right? I'm thinking of the area behind the range hood, which will go from counter top to ceiling.

Thanks for the tips! Fortunately, we'll only be going 1/2 way up to the bottom of the cabinets. I think there is a 1/4" height difference over the course of 8 feet. Not too bad. I have a plastic rafter square that I think will work well to "align" the tiles...so thanks for that tip Nestor...

Howdy all. We really like the look of 1-inch (nominal) glass mosaic tiles. We have purchased several "sheets" (12 x 12 inch nominal) and will be putting them on the kitchen walls. I have purchased white thinset (premixed), and plan to use an unsanded white grout to finish. I have a few...

Thanks for sharing your experiences...that's exactly what I'm looking for. I do appreciate the knowledge here (Wuzzat?, Nestor, others), sorry if I came off sounding otherwise.

Dude, I get it, you're smart. But, you don't answer questions very well, honestly. I asked: What is the difference between a hand grinder and an angle grinder?

OK, I'll post up some options I'm looking at. BTW - what's the difference between an angle grinder and a hand grinder? The photo of the Bosch is what I'm referring to.

Nerd alert! OK, thanks for the science lesson, but really I'm looking for brand/model suggestions. I don't know the specs of the ones that have failed me, but I do know they were very cheap tools from places like HF. They were both gifted to me, so I just used them with abandon. Whichever...