Recent content by taviaromescu

Thank you.

This water heater was installed in our mobile home by the previous owner. It suddenly just stopped heating water recently. So I was looking at the manual, and says on there that this model must not be installed in a mobile home, but doesn't say why. I called the Rheem technical support dept...

The gas, stove, and the whole house are *her* property, and she s not being sensible about this. I guess I have to call the fire dept. and ask their advice.

Well I am having trouble registering for that forum, so any help I can get here would be appreciated. The flame is more yellow than blue.

Thank you

The oven has a problem, and we have to wait few days to hear from the repairman. My mother intends to use it anyway, even though I bought a CO meter and checked the oven. I found that the CO level went to over 100 ppm very quickly - after turning it on. If she tries to cook, it is likely to...

So I thin it is using up more gas than is necessary, plus the as leak is not healthful.

I'm cooking chicken in there right now, and there is a wave of heat coming out of it. I put a chair in front of it, and put a digital room thermometer on it. It was about 88 degrees in my bedroom. Four feet from the oven, it's at 96 degrees. Even when it's off, the air inside the oven is...

Ok so I ran the machine with nothing in it, and the loud banging was gone. Clearly I have to stop the machine and re-distribute before the final spin. But I would like to fix it. The barrell or whatever you call it, seems loose. It moves eaisily. If I push on it, it easily tilts to one side.

It's right at the end of the cycle, right when the machine is trying to slow the spinning down. Is it dying?

Thank you, I'll make sure to give it time to dry.

I've been trying to get it dry for 1.5 weeks. I think I will just put down vinyl tile flooring. Thank you everyone!

Ah, the clog was caused by chicken grease from an upstairs condo. I'll try that, thanks.

I recently had a handyman unclog a kitchen pipe, and he failed to use a any kind of bucket while doing so. He got both water and chemicals all over the particle board. He cleaned it up, but one particular spot got really damaged. It became discolored and swelled. I don't think mold is a...

Further thought: would one ordinarily do this only if one actually sees mold damage on the the wall or ceiling , and/or smells mold? I ask because that is not the case here.