May have seen this on one of those DIY websites of hacks.
Worst case scenario is that the cardboard would become laden with grease, the weight of...
Totally possible if the water froze before drying.
Looking for some advice. A few years ago I treated my wood deck with Cabot's solid color water repellent.
The color has faded and/or...
wrap the switch and/or outlet with electrical tape to cover the lugs to prevent a problem with accidental contact/shorting.
Assuming capillary tubes in place of a TXV?
Leak testing can get really expensive and that's why most customers opt for the "gas & go" approach.
Careful on this approach, I burned up a shop vac by doing this. They aren't designed to pull through suck a narrow tube. If you quick about it,...
It actually looks like the pad is level but the unit is not.
Put some more shims under the pad if this is not the case, eventually it will level...
Back the springs off a turn or two then lock the set screws down.
Check the fins on the blower wheel. I had a Trane unit just let go of all the fins on the wheel and scattered them everywhere. Obviously, put...
Process of elimination.
What happens when you put a incandescent bulb in the fixture?
What happens when you put the LED in a normal lamp socket?
Completely off subject but, it sounds like this bedroom may not have a legal egress window size.
clean or replace the flame sensor. Might need to replace the sensor and ignitor as a single component.
I'm reading this as the OP wants to have two thermostats attached to one furnace.
While conceptually the same, the guts differ from maker to maker. Replace the entire assembly.
I have seen one instance where the inducer motor would run but, not fast enough to "make" the pressure switch.
Maybe some return air registers are...
Well that's not good. What happens if you prop the door open so the furnace can breath?
While the pin spread between T12 & T8 are the same, you can not put T8's in a T12 fixture and vice versa; with lasting results.
check for a blown inline fuse between the line power in the fixure and the ballast.
Yes, only one leg is switched and the fan will not run with just one leg.
The coil on the relay is responsible for pulling in the second leg to...
I have had a situation where the inducer blower motor is running just fine but, for whatever reason, over time it just wasn't getting enough...
Separate names with a comma.