Search results

go to lowes and get deep wire mold boxes and GFI plugs. You cant go from two blade plugs to two blade and a round ground, if there is no ground, must use GFI plugs

Put a # 4 on the metal water piping and a #4 on the ground rod( use copper)

you see to have line and load confussed the line is the hot wires coming into the box a black and a white normally and the load is the black and the white going down stream

Mopar. You have it right just do it. P.S. I have seen lots of houses with ceiling fans in bathrooms

more than likely its a GFI in another bathroom pull it out and check for voltage on the load side line and load are marked on the back of the plug

In my humble opinion you have a neutral problem start at the switch then the light then when you do the plugs try this trick plug a radio in and make sure it is turned on and loud to a known dead plug now go around to each plug and bang on it with the palm of your hand, if the radio...

tell momma to pick out some new drapes

Reguardless where you put it ,you will need a ckt for the washer and a ckt for the dryer. Hire an electrician and do it right the first time....don

No new ckt. required.

Put the plug where you want it . your good to go. Every 100 watts is about 1 amp (rule of thumb)...don

If there are no heating elements involved and there is only heat lamps, I see no need for a dedicated circuit. If heating elements are involved you will need a dedicated circuit, Check the manuel that came with the buffet. It will tell you what size circuit is needed if elements are invloved.