Search results

I have the Red wire hooked to blue wire thats says lights. No, I just put replaced an old fan with a new one.

I am trying to hook up hunter universal fan and light remote control model # 21784. When I hooked it up the way it shows nothing works. I put all the black to gather and the white and get on the motor to work but not the lights I have only one switch that the power comes from. I been trying...

My panel is in the ban and I would like change the location of it while I keep the power for my pool and my garage. Any ideas would be appreciated. Thanks

I am planning on replacing both buildings in the future. As the budget allows I am planning on updating things one at a time just starting with the panel in the garage.

The previous owner cut alot of corners when he did things so I am trying to clean up his mess and figure out what he did. From what I can tell the power to the barn is coming from my house main panel. The panel in the barn is an old federal pacific that has my lights and outlets on it. The...

It is 2 pole 100. The reason I panels out is because have my garage lights don't work any more and when you shut main breaker off there is sill power running to sup panel. The new panel is 125 amps. Since I am not using the garage much I thought this panel would be fine. Also just let you...

I hope these pictures are better. The main breaker in on the right and the sub is on the left. When I take the main out should I put plywood on the 2 x 4 to screw the new panel to are I should put it like the old is? Also The new Square D Home-line panel did not come with a main breaker. I...

When I bought this garage the main panel and sup panel looks like this. I am changing it out to Square D Homeline. Need adive on making right. Thanks

Since I am not using the outlets I am just leaving the breaker off till I get time to look into the problem.

I still can't find what breaker that shuts the outlets off. Can I short to wires to trip the breaker so I have to keep running to and from the basement?

The first outlet that is grounded proper with out a pig-till is reading the correct voltage. The other two have numbers from hot to ground are lower. Hot to neutral numbers are the same. When I check the outlets on the other side of the room they have no pig-tills and have correct readings.

Sorry I didn't get back sooner had a family emergency to take care off. Upon a closer inspection I found three outlets that I am working on are not tired in with other three. The first outlet is grounded proper, but is set is the same with the two that has an open ground. I pig-till the middle...

If I wire nut the bare wires together then I don't have enough length to put around the screw. I guess my only option is to put back the way it was and leave the outlets with an open ground. I don't like doing things this way. I like doing things the right way.:(

If this is the case then why would it trip all of a sudden when I haven't used the outlets yet? So I guess I take the panel off and check the wires.

Can I wire nut the two ground and put around the screw? Please explain about what you having me do. Thanks

I have 2 outlets inside the utility room and 2 on the outside. What I don't understand I have not use these outlets and all of a sudden the breaker trips.

I have gas heat and so far I can't find yet what is not working.

I have 200A main panel for the house. There is 20a breaker that keeps tripping and have no Idea what is causing and what is hooked up on the breaker. Would appreciate someone telling me what is causing and where do I start looking. Thanks Daniel

In a small bedroom there are 6 outlets. The last two have an open ground upon inspection the ground wire is twisted around the bare wire that is connected to the green screw. Is this correct or do I need to take the one wire put around green screw? Thanks